CBC Motorcycles

Call Directions Website Contact the business

CBC Motorcycles CBC Motorcycles offering comprehensive servicing, dyno tuning and full bike preparation from our workshop In the centre of Plymouth

Sometimes off the shelf doesn’t do the job….we can spec springs to suit most applicationsWe shortened the unit earlier i...
28/10/2026

Sometimes off the shelf doesn’t do the job….we can spec springs to suit most applications

We shortened the unit earlier in the year, it came back in for a shorter spring with a lighter rate as the sag wasn’t where it needed to be on this land speed bike project

Colour matched springs available for most applications, contact us with requirements 🏍️🏁

Suspension refresh season is upon us…one of the neglected areas, unfortunately often left to fail before getting the att...
23/10/2026

Suspension refresh season is upon us…one of the neglected areas, unfortunately often left to fail before getting the attention deserved

Got a steady flow of jobs getting sent down to fit around the workshop bookings

Set of CB500 forks we got the lowers vapour blasted before rebuild, linear springs suited to the riders weight ready for the grid next season

And, another set from a good customer who’s building something new for next years classic days. Emulators, again linear springs and new spacers machined up to give just the right amount of preload 💪

Reach out with what you need and we can get you taken care of ready to get booking dates as they are released 🏍️🏁

Had a few steering dampers to work through this week…Nice Ohlins for a Fireblade project someone is working through. Fre...
20/10/2026

Had a few steering dampers to work through this week…

Nice Ohlins for a Fireblade project someone is working through. Fresh stickers will be worth a good few seconds on track 🏍️💨

The 3 Toby dampers are actually from a light aircraft, we have supplied a few of these to owners as the design of the plane has a tendency to damage them if there is a hard landing 🛬

Of the 3, only 2 could be repaired, the amount of parts replaced is always a surprise! Last photo is all that’s gone in the bin from the 3.

First time we have ever run a camera on any of the bikes…obviously you know what’s gonna happen 🤔Worrying, (and embarras...
14/10/2026

First time we have ever run a camera on any of the bikes…obviously you know what’s gonna happen 🤔

Worrying, (and embarrassingly) we had quite a serious leak from the left fork leg, enough to cover the front tyre and also the rear resulting in a warning slide before completely letting go

Turns out when assembled, the thread lock on both of the stanchions wasn’t on the thread at all so may as well not have been there. The left stanchion twisted itself off enough to dump all the oil, the right was close too doing the same

Luckily, only a small knock and was the slowest part of the circuit. 2 turns later and it would have been flat in 4th 😳

Certainly not something you’d find as a problem on any of the big manufactures forks. But I know if we ever replace these on the pit bike, anything new will be fully striped and checked before going anywhere near the bike

Missed 1 session, but were able to fix both correctly, fill with fresh fluid and get back out ☀️🇪🇸🏁

We spotted  casually letting his spindle sit in the Spanish dust during a tyre change after 2 hard days at CIRCUITO DE J...
12/10/2026

We spotted casually letting his spindle sit in the Spanish dust during a tyre change after 2 hard days at CIRCUITO DE JEREZ (oficial) and needed to intervene….No Limits Trackdays instructors need to lead by example 💪

Paddock Pal Uk got his shaft off the dusty mat and surely contributed to the following days lap times 🏍️💨🏁

11/10/2026

No Limits Trackdays Jerez 3 day event just finished 🇪🇸☀️

Great to be back on a Spanish event and catching up with everyone in the paddock again. Busy few days for us….

Set-ups helped some to set PB’s, others to dial in new to them bikes and a few mechanical issues assisted with along the way too. One of the riders, after a few tweaks had the feel from the front to get their elbow down for the first time 👏🤟

This time last week we were at Donington Park for the final round of Moto 4 with BSB.Few miles later, today we are all s...
08/10/2026

This time last week we were at Donington Park for the final round of Moto 4 with BSB.

Few miles later, today we are all set up in CIRCUITO DE JEREZ (oficial) ready for No Limits Trackdays🔥

Looking to be amazing weather with great company ☀️🇪🇸

01/10/2026

It feels like only yesterday we were discussing with MPS Motorsport supporting their track days this year!

A fantastic season of Castle Combe Circuit track days, looking forward to the 2027 calendar being announced 🤟🏍️💨

28/09/2026

Not every day you get the opportunity to work on a piece of racing history like this!

John Reynolds championship winning bike from 2004 in for wheel and tyre change with us at the Classic Bike Trackdays Cadwell Moto 🏍️💨

ContiMoto UK taking care of the tyre change while we worked out a solution for the quick release rear spindle 🛞

27/09/2026

Cadwell Moto ✅

Last of 2026’s Classic Bike Trackdays events, and what a weekend ☀️🏁 Huge thanks to Rob and Darin for another cracking season

Nice cold b**r to finish the day before we head off tomorrow morning to Castle Combe Circuit

Address

14 College Lane
Plymouth
PL47AW

Alerts

Be the first to know and let us send you an email when CBC Motorcycles posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to CBC Motorcycles:

Shortcuts

Share

Nearby cars & car services