Heifner's Repair and More

05/04/2026

25 hp kohler threw a rod and cracked some cases. This one isn’t salvageable. Time for a new motor.

04/06/2026

Full service and deck cleaning on this 60 inch. Picked up and delivered back within the week. 👊

12/18/2025

12/18/2025

Another one to check off the list ✅ Here we have a brand new OEM motor from john deere installed after yanking the old one out. Swapping over a few parts from old to new and some new rear nuckle bearings going in + new belt. Picked up and delivered back to a happy customer!!

12/04/2025

Quick little tune up on a generator. The Float Needle was stuck in carburetor not letting it get any fuel. Oil change also, its ready to go.

11/20/2025

2011 Chevy cruze 1.4l turbo. Decent little job here resealing the oil cooler. On the way down to it i found most of the lines were made of plastic and also the water outlet in the 6th picture. They were all brittle over time. New Aluminum parts are the way to go. All new seals and aluminum on the way out shes ready to go!

10/04/2025

Quick little bearing swap before a trail ride 🤷🏼‍♂️ you want maintenance before the ride, not during the ride!

09/15/2025

Welp my personal bike finally had enough.. We went from the track straight to the workbench this Sunday. Time for a full rebuild!!

07/31/2025

Who has a project they need finished/rebuilt? 🤔 Mowers, atv’s, bikes, boats. Shoot me a message!!

03/16/2025

96 polaris scrambler 400
The rear end was suppose to be bad, it was taken out only to find a snap ring slipped up out of its grove. New snap ring and gasket/oil everythings just fine👍
Headlights on the way
New master cylinder
New front tires installed
All new oil
Battery
02 polaris preditor 90
New top end piston and gaskets
Air cooling line
Battery
Carb clean
there both ready for the dirt 👍
Shoot me a message if you need anything done!