R&R Motorsports

01/06/2023

Another custom alignment done! Tire wear won't be much of an issue with this slammed genesis anymore!
Appoint only! Schedule yours today!

11/15/2022

Tired of calling and fighting shops about getting your lowered, track, or drift car aligned? About to start taking appointments for custom alignments. Pricing will vary based off of type of suspension installed on the car. On car adjustable will be quite a bit cheaper than non on car adjustable. Message me to get setup and get your car done right!

11/08/2022

S550/s197 mustang to LS engine swap mounts built in house

10/22/2022

10/09/2022

2007 mustang GT I coyote swapped to have a baseline to know what to do as well as how to price a swap. Labor cost for a swap like this is 5k. The rest of the cost is up to how good of deals you can get on a drivetrain. But expect total cost to be somewhere around 12k

10/09/2022

3" lift I finished up on a 2013 tacoma yesterday!

07/24/2022

Before and after of a gmc truck with a bolt inside the cylinder. Should have it finished up tomorrow and ready to go back in!

06/21/2022

Yes this is the same car! My engine and trans will live on in this chassis as a daily/drifter. Goal is to be easy to drive, reliable, with as little modification as possible. Angle, coils, hydro at most. The best part is having 4 seats again and I'm sure we will put the trailer hitch behind it to street drive to some events again. 2jz car is going to be insane but there is no hurry to get that car back on the track until cost of travel and living comes back down a bit. For now I'll focus on learning and building it the way I want

06/05/2022

2jz coming together for one of the s550 mustangs 🤩 pistons rings and 86mm compressor will be here this week. This build will be using oem GTE internals in a GE block. My gte block is bored. 20 over so it's going to get forged pistons and I already have forged rods for it and it'll be a backup short block.

05/22/2022

S197 we picked up about a week ago for my wife a daily/drifter. Ofcourse I couldn't go without messing with it, so its already got 4:10's and I modded the knuckles. Couple more things and it'll be a great seatime/learner car

01/16/2022

Been super busy lately and haven't posted, I'm also in the middle of an engine build on this 2014 camaro ss!