Slomaro Gear LLC

12/10/2025

11/03/2025

2006 Nissan Frontier Heater core replacement…customer has a checklist this is first of many…
Chasing down codes for other issues now starting with a knock sensor bank 1 circuit high code found a rat chewed wires completely off

09/29/2025

5r110w
Pump updated with steel PR valve, Vent relocation, removed l**e plug to thoroughly clean l**e circuit in pump, welded coast drum, updated low/reverse snap ring, updated forward RG snapring, updated HD direct drum bushing update, updated SONNAX manual valve, new VB, Stage II solenoids, Triple disc Billet convertor, Blue molded pistons, added shim to tighten output endplay from loose factory 0.030” to 0.005”, cooler bypass delete (this is a must on everyone of my builds if applicable)

**more pics to come as build progresses**

09/26/2025

Customers 1998 Dodge Ram 3500 Dana 80 caught it in the nick of time….full axle swab and bearing refresh

09/22/2025

2014 Ford F150 (5.0L) in my buddies truck walking him through rebuilding it after he did his axle…Units symptoms were starting in a higher gear in “D” (2nd Gear) and Reverse acted like neutral

**UPDATE: He’s getting there…great job Devon Hand**

09/16/2025

BW44-47…..ran with no fluid complaint was transmission would clunk into reverse and act like neutral and when trying to put back in park would grind…customer thought it was a transmission problem….this is the magnet newer style BW44-47 and a non-magnet style…nothing stops us here….a rear case swap and mainshaft swap with a rebuild and back on the road

09/06/2025

2014 Ford F150 9.75 rear axle grenaded….my buddy brought it to me….so I could walk him through building it….he did a great job

08/28/2025

Customer wanted one of our fully remanufactured 6l80e….5yr warranty/ Unlimited Mile with nationwide coverage dyno’d transmissions….sure might be a little more than other local shops….but two things set us apart Dyno’d confirmed workmanship and the Massive 5yr warranty…best on the coast is around 18months

08/21/2025

Customer came in with low oil pressure alarm on his 2.8 Duramax after an oil change hasn’t driven it for a while…..symptoms were when engine is cold there is no issue…when engine is warmed up and you kill engine and start it back up you get 5-7psi and alarm…rev a little and pressure gets 13-14psi and stays…checked with mechanical gauge and verified same symptom to rule out sensor and electrical….pulled filter and immediately noticed the oring…installed a WIX no more issue…..when buying a cheap made in China bundle on Amazon buyer beware

08/07/2025

Early 2000 Late 1999 4l60e

07/26/2025

2017 Chevy Suburban AFM/DOD delete

07/14/2025

2012 Ford F150 (5.0) 650hp built 6r80