KAMS Precision Engines

10/17/2026

#454 on the pump. Unfortunately the dyno was having a glitch and won’t hold past 5800rpm but power was still on an upward trajectory. Older rotating assembly into a freshly machined block topped by some older 90’s era as cast BRODIX Inc big Brodie heads that we freshened up. Going to be used for a Bullet Racing Cams Bam Roller Lifters

10/17/2026

The definition of success!! 14 broken exposed exhaust studs and 4 buried successfully removed, so much fun 🙄. ,still the most versatile machine ever made.

09/11/2026

Big thanks to Turbo Mike Tuning for getting our ChampCar Endurance Series tuned in. After struggling for a while trying to self tune without a dyno or enough knowledge to properly set up the software, Mike took a few hours with us to fix what was a few seasons of struggling, looking forward to the next event to truly ring out the finally at its full potential. Also thanks to Chris Rudnik for introducing us to Turbo Mike

09/01/2026

Sizing the Speed and Science custom billet cylinders in the COMEC SRL afc200 cnc. For Fuller Performance & Fabrication

08/27/2026

COMEC SRL sleeve job on this cylinder L.A. Sleeve Had to remove almost .400 , lots of chips 😁

08/27/2026

If you can’t buy the bearings you need just make them work 😎

08/23/2026

Summit Racing retrofit hydraulic roller cam really sounds great out there exhaust. Too bad the Header leak takes away from the video, didn’t sound as bad in person 🤷🏼‍♂️.

08/22/2026

#440

08/22/2026