05/26/2021
4 &6cyl fwd rules
1.car must be factory front wheel drive.
2.all glass must be removed from vehicle, removing front windshield is optional.
3.airbags must be removed, not just disconnected.
4.doors can be wired,chained,bolted shut, drivers door may be welded solid.
5.no reinforcing subframe, no added bolts or plates.
6.battery can remain in stock location,or moved to passenger side floor board and securely fastened.
7.must have helmet,eye protection,and working seat belt
8.can use any4 cyl v6 fwd bumper ,or swap to a 98-02 p71 vic bumper,all bumper covers must be removed.
9.if parts are changed in between heats,they must be in accordance with the rules, if not car will be disqualified
10.no carb swaps,this is meant to be a stock class
11.notching rear frame is ok
12.4 point cage inside of car is allowed,cannot pass through firewall,and cannot go further than 6 inches past drivers seat
13.car must bounce,will be checked after derby.
14.no minivans
15.wire,bolt,or chain trunk in stock location, if you v the trunk you will take it off.
16. No creasing whatsoever.
17.aftermarket or sleeved tie rods allowed.
18.any wheel tire combo allowed, no studded tires.
19.will have two chances to pass tech,after that entry fee will be forfeited.
20.inspector has final say.
21.if you try to push the grey areas you will cut . No arguing it wasn't in the rules.
22. If it doesn't say do it in the rules don't try it. Push the grey areas and you will be loaded.