Goff's Welding Garage

06/27/2025

05/03/2025

Got to custom fab a set of 1/4" plates, which will be the platform for a set of umbrellas. The brackets bolt right to the side of a deck, and umbrellas stand "tube" will bolt to the smaller platform. Ones prior to this set were made with very thin material. Super happy with how these came out.

12/26/2024

Made a custom fabricated leaf-vac stand for Chris Funk, of Funk Landscape & Design's two axle trailer, came out fantastic, also great people check their FB page out as well if you are interested in landscape services near or around Charlton Ma. All corners are mitered and then welded to prevent open holes for water and etc. to build up inside. Also, drilled and and made the stand and leaf-vac bolt-able.

10/04/2024

Contact these guys for all your forestry mulching needs, great people, pricing, and experience!

08/02/2024

I recently just finished this Chevy Silverado pick up. A portion in the front of the truck, which is structural to the vehicle's frame, was starting to rust/rot away. Not to worry, I simply took two steel plates and welded them up and on the frame to help stop the rot and add plenty of strength.

06/30/2024

Welded two front hangers for a two axle dump trailer came out awesome!

01/21/2024

Installed a fully fabricated steel railing out of flat bar and tubing, came out absolutely great.

12/28/2023

12/28/2023

Chevy Tahoe needed all new rear torque arm hangers, fabricated four hangers, cut out the old and welded in the new.