RedMex Garage

RedMex Garage Repair most atv/utv and some full size vehicle work.

Got the parts swapped for the 2016 grand caravan. Went smooth just had to compress the sping to pull it out. Even with t...
05/09/2023

Got the parts swapped for the 2016 grand caravan. Went smooth just had to compress the sping to pull it out. Even with the tire off the ground still had some tension up in there.

03 sportman 700 with busted balancer shaft gear, crank gear, and oil pump gear. All swapped out and running great. Torqu...
05/06/2023

03 sportman 700 with busted balancer shaft gear, crank gear, and oil pump gear. All swapped out and running great. Torque master let me tell you. Changed phone and lost some pics

Got a little yamaha breeze that came in with low compression but passed leakdown test. Yup timing jumped and sheared the...
05/06/2023

Got a little yamaha breeze that came in with low compression but passed leakdown test. Yup timing jumped and sheared the cam gear lock tab. Parts are on the way "NOS parts" from japan.

Worked on this g3? Golf cart and got it going good. Nice little cart to haul the kiddos on.
05/06/2023

Worked on this g3? Golf cart and got it going good. Nice little cart to haul the kiddos on.

Wildcat 1000 update. Got the used diff used both to build the best with a new seal kit. 2wd, 4wd, and diff lock all work...
05/06/2023

Wildcat 1000 update. Got the used diff used both to build the best with a new seal kit. 2wd, 4wd, and diff lock all work. Got the used key switch and now it starts with the key. Also almost got the motor up to reseal the pan that has a small leak. Also have a used clutch cover to install Then changing rear dif fluid and 3gal of 91 octain see how she runs then.

Got alot of updates to catch up with. But first this fresh arrival of 2016 grand caravan lost its strut plate and popped...
05/06/2023

Got alot of updates to catch up with. But first this fresh arrival of 2016 grand caravan lost its strut plate and popped out and twisted the cv axle.

Well a update on the wildcat 1000x. Got the motor together and in. Runs great and actually moves now. But while tracing ...
04/11/2023

Well a update on the wildcat 1000x. Got the motor together and in. Runs great and actually moves now. But while tracing wires working on the key switch noticed oil buildup on the front diff and yup its blown in half also. Somebody must have been spinning super hard problem off a jump and found traction while wide open. Diff is now out a broke down. Gears are trashed and side cover is in 5 peices. Currently trying to locate a front diff. New is over 1.1k so pricey is a under statement but the MBC clutches feel amazing.

Well with this wind not to much going on today. However managed to get a class 1 hitch put on this 2020 Toyota Corolla. ...
04/03/2023

Well with this wind not to much going on today. However managed to get a class 1 hitch put on this 2020 Toyota Corolla. Pretty tight clean fit in my opinion. Had to drill out 1" access holes and wire pull the bolts and internal lock/washers. Typical imstall.

Got the oem gear put on the driveline shaft but when dry fitting the assembly to check gear mesh and backlash noticed it...
03/26/2023

Got the oem gear put on the driveline shaft but when dry fitting the assembly to check gear mesh and backlash noticed it had a tight spot. After further inspection the main shaft has alot of run-out. Yup its warped for the gears binding so hard. Got a oem one on the way already and still waiting on 3 seals.

Got the motor put back together with the used case half. Went together smoothly I must say. Now just waiting on bevel ge...
03/24/2023

Got the motor put back together with the used case half. Went together smoothly I must say. Now just waiting on bevel gears and output seals. It's almost there. Then we just Ned clutches, belt, oil, and coolant.

Got this motor pulled from the 2013 wildcat 1000x. Transmission decided to eject the secondary drive gear out the side o...
03/22/2023

Got this motor pulled from the 2013 wildcat 1000x. Transmission decided to eject the secondary drive gear out the side of the case. Got three ruined gears and 2 broken case sections. RH side and oil pan. Got the half case swapped and back together just waiting on the gears and few seals that were leaky. Motor looks amazing other than the hole in the side. Starting to wrap things back up but also needs both clutches guess they detonated when the tyranny popped. My guess is high torque and wheel speed meet hard surface and pop went the aluminium.

Got the yamaha moto 4 all wrapped up. Ran into some valve issues when it first fired up but it's all fixed now and purrs...
03/22/2023

Got the yamaha moto 4 all wrapped up. Ran into some valve issues when it first fired up but it's all fixed now and purrs like a kitten. Way quieter with the timing chain adjusted. First 5 mile break in done already and up to the owner to break it the rest the way and I'll adjust the valves at 25-30 mile more.

Address

Sorrel Road
Snowflake, AZ
85937

Telephone

+19282436052

Website

Alerts

Be the first to know and let us send you an email when RedMex Garage posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category