Xcellence by Tyrus

Xcellence by Tyrus Doing More with Less!

One of two coilover mounts made. It turned out alright tried to copy the QA1 mount for a G-Body.
03/26/2025

One of two coilover mounts made. It turned out alright tried to copy the QA1 mount for a G-Body.

This billet aluminum trim came in 6 feet lengths,but I had to weld on the remaining 20” inches I needed. Tig welding alu...
05/02/2024

This billet aluminum trim came in 6 feet lengths,but I had to weld on the remaining 20” inches I needed. Tig welding aluminum isn’t something I do very often, but it turned out alright.

It wasn’t easy replacing the whole floor of this Monte Carlo,but it’s done. It could have been a lot simpler if it was j...
02/15/2024

It wasn’t easy replacing the whole floor of this Monte Carlo,but it’s done. It could have been a lot simpler if it was just a roller with nothing in it. Also these cars are for short people because of where the factory seat location is I can barely get in and out lol.

This panel is turning out decent considering that I’m making it from scratch and I don’t have all the fab tools I need r...
12/29/2023

This panel is turning out decent considering that I’m making it from scratch and I don’t have all the fab tools I need right now.

I guess this is what they call paint ready because all this stuff was supposed to be fixed already by the previous perso...
12/11/2023

I guess this is what they call paint ready because all this stuff was supposed to be fixed already by the previous person. This is why I would rather strip it to bare metal and start fresh.

Out with the old in with the new for this 68 Camaro. Bringing the Camaro into the 21st century with a 4 link & coil over...
10/23/2023

Out with the old in with the new for this 68 Camaro. Bringing the Camaro into the 21st century with a 4 link & coil over conversion from the old leaf springs setup

Here is some rust repair work around the window of a 1968 Camaro that once had a vinyl top. Owner couldn’t find patch pa...
10/19/2023

Here is some rust repair work around the window of a 1968 Camaro that once had a vinyl top. Owner couldn’t find patch panels for sail panels,but he had the filler panel between trunk and window so I was like that’s no problem I’ll make it. I finished it up with some light body work and used an aerosol primer to seal it up until the owner has it painted.

Started welding a new passenger quarter panel on the 75 Caprice convertible because they were overlapped and welded inco...
09/29/2023

Started welding a new passenger quarter panel on the 75 Caprice convertible because they were overlapped and welded incorrectly. So we cut it off and started with a new one. The before picture is of the driver side, but the passenger side was even worse. Decided to TIG weld it so I would have a little more control. This is because the sheet metal was thin from being ground down for the overlap panels (previous person’s work done) instead of butting together.

Project 1995 Impala.. Getting it to showroom quality.
09/27/2023

Project 1995 Impala.. Getting it to showroom quality.

09/27/2023

Just a guy, a dream, and a love of cars. Follow me while I follow my passion of restoring old cars to their beauty: some original and some modified.

Address

Pinson, AL

Telephone

+12056151428

Website

Alerts

Be the first to know and let us send you an email when Xcellence by Tyrus posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Xcellence by Tyrus:

Shortcuts

Share

Category