Kody's Krooked Customs

10/04/2020

Thanks for the recommendation Doc Woolf. Pinstripe is done now to clear over.

10/04/2020

Thanks for the help Butch. Primer sealer, Black base, and intercoat clear.

09/12/2020

Well I wish I either had a paint booth or that it would quit raining as I need about 4 hours to seal color and clear the frame. I did try to cover my seat, and it didn't suck but I wasn't satisfied. So I'll try again.

08/27/2020

I sprayed acrylic lacquer primer on the frame today. Now to wet sand and spot puddy as necessary.

08/27/2020

A new addition to the KKC stable

07/09/2020

Got the passenger seats done. Going to sand the clear on the wood and recoat one more time. Still need to weld passenger floorboard mounts on the frame and top motor mount boss.

06/24/2020

06/24/2020

The resistor diodes came so I was able to wire my L.E.D.s in my electrical control panel. I still need to wire face panel into fuze panel in the can and to run wires out to the pin connectors to the rear end and such after final assembly. We still have a few more tabs and brackets to weld on the frame before I can start on the paint

06/19/2020

Well I've been working on the trike project a little more lately. I carved our logo in the back board. I installed the rivits in the hammered steel on the wood bed. Got the first set of clear marine varnish on the wood bed. Letting it cure before sanding and anouther set of coats.

06/01/2020

So it has been a while since either Kody or I posted. So much has been going on.
Kody bought the property and we have been doing repairs to the workshop. I also moved. We have been doing some work on the trike project. Some things take alot of work but not much to show. Here is a few pictures of the progress.

01/18/2020

Finishing up the gas tank on the trike.

01/14/2020

Custom mini receiver hitch for the trike ready for paint