Wyatt's Workshop

04/27/2026

2004 Chevy Colorado with a 2.4 L four-cylinder engine. Fuel injectors, fixed fuel injector wire loom, Valve cover gasket, and a rear differential service.
Ended the day diagnosing a faulty ignition switch on a 2006 jeep liberty with a 3.7L V6
As well as replacing 2 battery terminals and a battery on a 2009 Nissan Murano

04/26/2026

Yup shes extra loud at the moment🤌😂😂😂🤦🏻‍♂️
This was the first cold start

04/26/2026

Quick clip

04/26/2026

I had to replace my head gaskets and cylinder heads on my 2000 GMC Yukon XL with a 5.3L V8 engine. I upgraded from the 706 casting heads to the 862 casting heads. I still have to finish the exhaust but installed headers and deleted the EGR valve and lower O2 sensors. Still gotta go for a tune after I finish the exhaust. Gonna do another oil change and fluid exchange in a week and hope we can clear out the rest of that milk in there lol

04/26/2026

Alternator and battery replacement on a 2020 Hyundai Santa Fe with a 2.4L 4 cylinder engine.

04/26/2026

04/26/2026

Valve cover gasket on a 2014 Hyundai Sonata with a 2.4L 4 cylinder engine. Also replaced the high pressure fuel pump o-ring.

04/11/2026

Started off the day with brake pads all around on a 2013 Nissan altima. Proceeded to replace O2 sensors on a 2021 Kia soul after that I followed up with replacing the fuel pump on a 2004 Chevy Colorado. Rather than dropping the tank, we figured removing the bed was just as easy.

04/05/2026

Sorry for not posting much. Heres a little photo drop. Ill try to keep content coming regularly. Thanks for the support. 🏁🏁🏁💯💯💯

02/01/2026

Started off the day repairing an oil leak coming from an oil pressure switch on a 2013 Honda CRV with a 2.4L 4 banger

Diagnosed misfire on a 2003 buick lesabre with a 3.8L V6 last person that worked on this car thought they fixed these fuel injector wires. Ultimately needs tuneup and injector pigtails

Continued with an oil change on a 2005 Nissan Xterra with a 4.0L V6 which needs valve cover gaskets and power steering hoses

Then ended the day working on a 2005 Buick Park Avenue with a 3.8L V6 that needed a water pump and tensioner pulley assembly due to stripped tensioner pulley upon arrival. It also got an oil change