Zed’s Customs - Motorcycles and Powder Coating

10/27/2022

Front fender fiberglassed,brackets fabricated, painted and installed!

10/10/2021

Got the cx500 front wheel all done today. Ready for bearings and rubber!

10/06/2021

10/05/2021

Getting some powder coating done today. This color is Buttered Brass. I like to call it 70’s gold.

03/17/2021

Sorry for not posting in so long. Lots of life has happened in the past few months. But without further ado...here’s a few progress pics of the cx500 I’ve been working on. Hope you like them!

11/16/2020

Customer was stoked to get these on his corvette! They look like a good match too!

11/02/2020

Haven’t posted in a while. But check these valve covers I’m finishing up powder coating and clear coating. So red!

09/03/2020

Short video and a couple pics of my rear brake light switch setup on my ‘82 GL500. I think it came out clean. Opinions?

09/03/2020

Short video and a couple pics of my rear brake light switch setup on my ‘82 GL500. I think it came out clean. Opinions?

08/31/2020

Last photos of the day ( I promise). Just got my GL500 battery box from Rejuve Cycles. So I installed the Anti-Gravity lithium battery, ricks regulator/rectifier, and lithium battery tender. Looks so good!

08/31/2020

Got the GL500 rear end done! If it could be changed or replaced it was! It’s back to being a rolling bike again!