Dahlstroem Motorsports

Dahlstroem Motorsports Able to take care of everything from your check engine light on your daily driver to performance parts installation on your hot rod or muscle car.

Corvette 1973 Project part 1. Body off and frame work.
12/04/2022

Corvette 1973 Project part 1. Body off and frame work.

Unfortunately this 4.6 3Valve engine was too badly hurt after a day at the drag strip to be repaired. Crankshaft was bad...
06/05/2021

Unfortunately this 4.6 3Valve engine was too badly hurt after a day at the drag strip to be repaired. Crankshaft was badly damaged, cam bores turn up and cam phasers was not able to control cam timing. A new long block and 1 1/2 days later another happy customer out the door.

The cars during the last week have been two different types of jobs. Subaru had a bad head gasket issue and a Camaro wit...
11/10/2020

The cars during the last week have been two different types of jobs. Subaru had a bad head gasket issue and a Camaro with a lazy catalytic cover as we can tell by reading the volt outputs on the downstream O2 sensor.

08/24/2020

Turn the volume up!!!πŸ”Š

1980 Corvette project is done βœ… πŸπŸ‡ΊπŸ‡Έ
08/24/2020

1980 Corvette project is done βœ… πŸπŸ‡ΊπŸ‡Έ

Transmission showed very little mechanical wear, but needed new seals and a good cleanup. Drive train is now back in the...
07/28/2020

Transmission showed very little mechanical wear, but needed new seals and a good cleanup. Drive train is now back in the car and the exiting final assembly can start!!!

Engine is now completely done. Only new parts are spark plug wires, engine mounts and water pump. The rest have been dis...
07/15/2020

Engine is now completely done. Only new parts are spark plug wires, engine mounts and water pump. The rest have been disassembled, restored and put back together to keep as original as possible (very time consuming). Next chapter will be transmission.

Long block is 80% done for the C3 Corvette. Only using the best assembly- and cam l**e, Lucas Oil and Comp Cams 🏁
06/30/2020

Long block is 80% done for the C3 Corvette. Only using the best assembly- and cam l**e, Lucas Oil and Comp Cams 🏁

Front and rear suspension is done βœ… The car is ready for engine and driveline, but there is still some work to do in tha...
06/19/2020

Front and rear suspension is done βœ… The car is ready for engine and driveline, but there is still some work to do in that department.

One more section done βœ… before and after pictures of the Corvette during the restoration.
06/11/2020

One more section done βœ… before and after pictures of the Corvette during the restoration.

Steering and suspension parts are rebuilt, painted and ready to go back on the car. But first the rear end of the car wi...
05/28/2020

Steering and suspension parts are rebuilt, painted and ready to go back on the car. But first the rear end of the car will need some attention.

I don’t do this often enough, but here is a little update on a regular day at the shop. 1966 Nova gets a full service wi...
03/30/2020

I don’t do this often enough, but here is a little update on a regular day at the shop. 1966 Nova gets a full service with Tune Up and some smaller repairs and a 2017 Hyundai are here for a quick engine oil and transmission fluid change. New or Old? Check engine light or carburetor rebuild? I can get it done for you!

Address

330 Township Road 372
Ironton, OH
45638

Telephone

+17405476798

Website

Alerts

Be the first to know and let us send you an email when Dahlstroem Motorsports posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Dahlstroem Motorsports:

Share