Southern Classic Auto Resurrections

05/01/2026

05/01/2026

1971 Bronco, that was being built for trail fun/ driver. I sold a couple good stock ones to build this like I wanted it. Then this and that came long, so here it sits for about 12 years now unfinished. Has rebuilt 302, automatic , was three speed manual, prior owner added power steering and a Dana 44 front diff. Has new 4 1/2” lift springs in rear. , I have 5” coils for front not installed. Roll cage was never finished, have duff tube doors, factory doors are a little rough. Top is a bit rough and factory hood is rough. The A pillars had some rust, has been beefed up with steel plate, kick panels replaced with steel plate. Heavy wall tubing rockers, tubing cradle for front, I still have the factory inner fenders. Comes with 4” rubber flares, racing type seats with 5 point harnesses. Also like new 35” x12.50 tires. Runs, but hasn’t been moved from under this shed in years. I’ll be working on getting it out soon, hopefully on its own power.

02/06/2026

1995 F150 4x4 ext cab parting out. 302 automatic, inquire for parts.

02/06/2026

SOLD:: Update 4/25/26 the hood and grill inserts are now gone. 1971 F100 roller: 302 Shortblock is laying in bed. Automatic trans is still in place. Has power steering, Pretty rough ole truck, but not too far gone. Cab has some floor rust I believe it’s just in outer floor pan area and can be patched. Has fairly new windshield and rubber.. Cab mounts are solid. Doors have exterior corner rust, door bottoms are good. Fenders have some rust in bottom. I can repair the rusted areas for $40.00 per hour plus parts. The bed floor is beat up pretty good, it would be a good candidate to get a raised floor or wood plank floor. $900.00 this is Georgia where titles are rare as hen’s teeth on anything before 1985. Can provide bill of sale and LEO vin verification. Some states accept that. Some don’t check with your dmv

If we start parting it out: auto column $200.00, power steering box $250.00. Doors 150.00 to $250.00 each windshield $200.00, cab $350.00, bed $300.00, rolling frame $500.00
Inquire for other items. We do have other parts , also have other trucks… 67-79

12/24/2025

1971 F100, SWB. Ranger XLT, factory red on red, factory 390, auto, PS, PB.. very solid and straight truck, runs good, drives good, stops good, has a tapping rocker arm, but a lot of FE’s do. does need a little work to be a driver. This one would be one to restore back to near original condition. The cab and hood are in primer. Yes, it does have a 69’grille and bed on it. $6500.00, it’ll get up and go for a stock 390 2 barrel, it will light up
One tire from a dead stop, not holding brakes, will even light it up from a slight roll. It’ll make a good driver. It has some exterior rust, door corners, bottom fender etc, I can replace for extra $$$.. Trades you ask? 67-79 F250 4x4, Jeep commando, Toyota FJ55, fj40, small 4x4 tractor Deere or new Holland, Massey preferred, ATV 4x4 or side x side. Mustang Fastback project, or ????. Have a few more I’m selling if you scroll through my page.

12/24/2025

Picked up this F100, 302, 3 spd. Has some rust. Might be a good one for one of my 4x4 chassis.

12/24/2025

I’m wanting a 1976-1979 F250 4x4 to fix up for a work truck, needs to be pretty complete. Engine not important I have a 460. May be interested in a 87-97 F350 4x4 std cab…

For sale; 1971 F100 roller: 302 Shortblock is laying in bed. Automatic trans is still in place. the trashy side, but it’s a cheap F100 that’s definitely buildable. Rust in bed floor and beat up, a good candidate for a raised floor or wood plank floor. Some rust in outer cab floors. 302 shortblock is laying in bed. Had power steering and has auto trans still in truck.

12/24/2025

1969 F250, a great project truck, 390, four speed. Overall really solid truck as far as bed floor, cab floors, cab mounts etc. Has a little superficial /typical rust, like door corners, bottom front fender and lower rear quarter. Believed to be actual mileage 61k as seat is great cond as is the rubber floor mat, the pedals show very little wear and engine is clean. It will run, but not running. I’m offering this truck at a reduced price, before I do anything else to it. what I do know: needs carb rebuild, needs distributor cap and rotor button, gas tank needs to be cleaned out, needs fuel pump, needs master cylinder. The truck is $2,300.00 as is.
I do have other trucks and parts I’ll be selling: short wheel base and long wheel base trucks.

11/24/2025

Will this be my last purchase for a while? I’m trying to cut back. The one before this was intended to be the last one. Really I had been watching this one for months, had a little discussion about it. Well as it goes I sell a truck, later that evening the price drops a lot on this one. Well, here it is in my possession. Mainly wanted that tool box bed for my personal truck.

11/21/2025

One week I had three to leave, then four more came along, had one leave Tuesday, brought in another one Wednesday, had this one leave today. I’m not bringing in anymore.