Classic Cadillac Parts

06/17/2026

06/17/2026

https://www.facebook.com/media/set/?set=a.1597730141808963&type=3
Very Good Used 1964 Cadillac Rear Control Links - $100 each

I have 4 sets of rear control links, and pulled my best set as seen here. These came off a 60K mile car, have not dents, only surface rust, and bushings are not bad, and probably OK to use for the foreseeable future.

FITS: 1964 Cadillacs except 75 Series and Commercial Chassis.

ALSO: Per Cadillac Master Parts Book, these were sold and used on 1963 Cadillacs, as the 1963 style was depleted so these also fit the 1963 Cadillac, but will have a different appearance from factory.

PRICE: $100 EACH or $200 for pair

EMAIL ME at [email protected]

06/17/2026

https://www.facebook.com/media/set/?set=a.1599718514943459&type=3
(BACK IN STOCK) Nice Tested 63 Front Park-Turn Signal Light - $80

Here is another very nice 1963 Cadillac Front Park & Turn Signal Light that I have cleaned and tested. See light tested with bright filament then dim filament in 2nd & 3rd pictures.

PRICE: $80 each

EMAIL ME at [email protected]

06/17/2026

https://www.facebook.com/media/set/?set=a.1602332614682049&type=3
Misc 63-64 Cadillac & Other Year Engine Gaskets - $6

I have sorted out my new smaller engine gaskets I have accumulated over the years and have them for sale for $6 each.

SEE LETTER NEXT TO GASKET IN PICTURE AND MATCH BELOW FOR DETAILS:

A: FRONT ENGINE COVER (fits 1963 to 1967)

B: WATER PUMP (fits 1963 to 1967)

C: OIL FITER MOUNT & SUPPORT (includes both gaskets, fits 1963 to 1964, 1965 Series 75)

D: WATER OUTLET PIPE TO HEAD (fits 1963 to 1967)

E: THERMOSTAT HOUSING TO OUTLET PIPE (fits 1963 to 1979)

F: OIL PUMP COVER (fits 1963 after VIN 136799, 1964 to 1965)

G: OIL PUMP COVER (fits 1966 to 1967)

H: DISTRIBUTOR TO FRONT ENGINE COVER (fits 1963 to 1974)

I: WATER OUTLET PIPE TO WATER PUMP O-RING (fits 1963 to 1967)

J: FUEL PUMP GASKET (fits 1946 to 1967)

06/17/2026

https://www.facebook.com/media/set/?set=a.1604066361175341&type=3
Fair to Good 1964 Cadillac Front License Guard - $30

These front license guards get bashed up pretty bad and didn't think I had any decent ones left but this 1964 Front License Guard cleaned up well. It does have a noticeable but not major ding on one edge. It had some minor corrosion on the inside ( but still very solid) and cleaned it up and sprayed with rust prohibitor to protect. This would be an OK daily driver or great piece to repair the ding and rechrome.

FITS: 1964 Cadillac

PRICE: $30

EMAIL ME at [email protected]

06/17/2026

https://www.facebook.com/media/set/?set=a.1605088297739814&type=3
Misc 1963-64 Cadillac Power Trunk Parts

I currently have all of the 1963/64 Cadillac Vacuum Power Trunk Parts available EXCEPT the Bowden Pull Down Cable. See the first picture with each part shown as a reference with items identified by column. I also have the large vacuum reservoir seen in the last 4 picture. If you need something EMAIL ME at [email protected].

1ST COLUMN TOP TO BOTTOM
- vacuum release line from glove box to the vacuum release actuator up in the trunk lid.
- clips holding vacuum line in place in trunk
- Bowden cable from back trunk wall actuator to the pull down mechanism on right trunk hinge  this is the only part I do not have

2ND COLUMN TOP TO BOTTOM
- brackets tack welded to back trunk wall for mounting pull down latch mechanism
- pull down latch mechanism
- pull down latch mechanism cover

3RD COLUMN TOP TO BOTTOM
- wiring harness and trunk open indicator light from dash to latch mechanism
- upper trunk latch (different than non-power trunk latch)
- trunk release actuator that mounts up in trunk lid fed by green striped vacuum line
- trunk floor bracket that holds the pull-down cylinder in placed (tack welded to floorboard)

4TH COLUMN TOP TO BOTTOM
- trunk hinge bracket that guides and keeps vacuum line on place and tack welded to trunk floor under right trunk hinge area
- pull down cylinder latch mounted to right outside of right trunk hinge which cylinder attaches
- pull down cylinder attaches to latch at top and Bowden cable that feeds thru pull-down latch at bottom.

06/15/2026

https://www.facebook.com/media/set/?set=a.1608111127437531&type=3
Cad Plated 63-64 Coupe/Conv Door Latch Assembly with Screws - $60

For the first time I have cad plated left and right 1963 to 1964 Coupe & Convertible door lock/latch assemblies including the 4 Phillips screws, with new gold cadmium plating. To get these in like new condition I took the best six left and six right latch assemblies and degreased and and cleaned and had them cadmium plated. I also installed 4 cad plated Phillips head mounting screws in each latch.

FITS: 1963 & 1964 COUPES (6257, 6357) and CONVERTIBLES (6267, 6367)

PRICE: $60 each side

EMAIL ME at [email protected]

06/15/2026

https://www.facebook.com/media/set/?set=a.1609004020681575&type=3
Cad Plated 63-64 Sedan Front Door Latch Assembly with Screws: $60

For the first time I have cad plated left and right 1963 to 1964 Cadillac Sedan Front Door Lock/Latch Assemblies including the 3 Phillips screws, with new gold cadmium plating. To get these in like new condition I took the best six left and six right latch assemblies and degreased and and cleaned and had them cadmium plated. I also installed 3 cad plated Phillips head mounting screws in each latch.

FITS: All 1963 & 1964 Sedans except 75 Series

PRICE: $60 each side

EMAIL ME at [email protected]