Xclusiv Audio

06/19/2026

Diamond Audio NEO15006 DSP amplifier installed in the 2021 Kenworth with the new sub enclosure we built. There is also a Sundown SIA-1750D installed behind the enclosure out of view.

06/19/2026

2021 Kenworth - New Head Unit

Our goal is to install a Sony XAV-AX8100 into this area of the dash. The problem is if we install it where the original radio was, then the screen either blocks the gauges above it, or the switches below it. So we thought about mounting it in the area where the larger pocket is on the right, but then it's a little far away from the driver. So... We did a little re-wiring. A little disassembling, and a lot of 3D printing, and decided to put it in the area where the gauges were. :)

First we started by moving the gauge panel into the area where the pocket used to be. A little wire and hose re-routing and that part wasn't too bad. Now we ran into an issue where the screen+ chassis of the radio were too deep to get the screen to sit nice and flush like we wanted it to. So time to start tearing down the radio!

A custom inner dash piece was made to hold just the chassis of the Sony head unit. We then routed the ribbon cable for the screen out of the front and into a cavity where the connector from the screen will recess into.

You can also see the plate we made to go where the original head unit was. This houses the Sundown amplifier bass k**b, a USB port, and also holds the two crossovers for the front component speakers in behind.

Now onto getting the screen mounted!

06/18/2026

2021 Kenworth - Front Tweeters

To finish up the front stage on this truck and fit the tweeters for our Arc Audio components, we modeled up some new pillar pods. The pods were then printed, sanded, painted, and then mounted onto the A-pillars for a perfect fit.

All of the new speakers in the truck are powered off a Diamond Audio NEO Series 6-channel DSP amplifier mounted on the wall under the rear bunk.

06/18/2026

2021 Kenworth - Door Speaker Upgrade

The original speakers in the doors of this truck were some very cheap and horrible sounding 4x6's. To install the new Arc Audio 5.25" component speakers we wanted, a little cutting needed to be done. We trimmed the door panel, and then 3D printed some adapter plates that were then epoxied into place and sealed. The new speakers then bolted right in place perfectly.

06/17/2026

2021 Kenworth - Rear Speakers

The truck had speakers in the lower area of the rear sleeper, so we replaced those with new Arc Audio X2 Series 6.5" coaxial speakers. Then we added two matching 6.5" speakers to the upper half of the sleeper as well.

06/16/2026

2021 Kenworth - Sub Enclosure

We are installing a Sundown SAv.3 12" subwoofer under the rear bunk of this truck, and we sort of had a limited space to deal with due to an HVAC system, needing access to an electrical panel, the shock for the rear bunk support, and wanting to leave a little storage space for the owner. So we started with a CAD rendering of the enclosure, to make sure we had the right airspace, port area, tuning, etc necessary for the subwoofer. And keeping it in the space we had to work with.

Once we knew we could fit everything properly, we cut out all the pieces of the enclosure, and got to work building it, Then we finished it in an epoxy bedliner material. The enclosure was then bolted to the floor under the rear bunk.
The subwoofer will be powered by a Sundown SIA-1750D amplifier (rated 1750W RMS @ 1-ohm), also mounted under the rear bunk.

Check back for more of the build in this truck!

06/11/2026

Super clean install Rishi did on this Cherokee using equipment supplied by the customer.

We made a seperate floor below the factory rear floor for the amps, line output converter, and power distribution to mount to.

We also made an additional strap to hold up the amp rack like the factory rear floor, giving easy access to the spare tire if needed.

06/08/2026

06/02/2026

Cruisin’ For A Cure Trophy Sponsor Spotlight: Xclusiv Audio

High-performance cars deserve high-performance sound — and Xclusiv Audio is helping bring that energy as the Trophy Sponsor for the “Moderns” class at this year’s Cruisin’ For A Cure Car Show!

From remote starts to custom audio systems, Xclusiv Audio helps drivers upgrade their rides with the latest in automotive technology. Whether you’re looking to turn up the volume, add convenience, or customize your vehicle with expert installation, their team delivers style, precision, and performance.

Thank you, Xclusiv Audio, for supporting Cruisin’ For A Cure and helping us keep things loud, proud, and modern while raising funds for the Maine Children’s Cancer Program.

Learn more at findmyremotestart.com or follow Xclusiv Audio on Facebook.

06/01/2026

Happy Monday everyone! And welcome to June!!

Let's kick this week off with this subwoofer install we did in this 2023 BMW 3-Series.

Two Sundown E-series 12's, powered by an Marts Digital 1000W amplifier. With a little custom amplifier rack to mount the amp next to the battery.