Nutbusterz Garage

Nutbusterz Garage From simple repairs to complete overhauls gas or diesel

Ac mode door actuator & the recirculation actuator (not pictured) replacement done on this benz
09/03/2026

Ac mode door actuator & the recirculation actuator (not pictured) replacement done on this benz

def injector clogged up and started to make a mess & going into reduced engine power. Replaced the def injector & perfor...
08/27/2026

def injector clogged up and started to make a mess & going into reduced engine power. Replaced the def injector & performed manual regen & reset the parameters. Back to work she goes.

08/27/2026
F250 got new front driveshaft u joints. Truck had a vibration up front, we check all steering components and everything ...
08/25/2026

F250 got new front driveshaft u joints. Truck had a vibration up front, we check all steering components and everything checked out. We had to pull the front axle shafts and check the u joints out cause with them in the truck, they seemed to be fine. But when we pulled the they had hard spots in them, so we replaced then and back on the road its goes.

Spark plug blew out and it could not be repaired. So the head came off & was replaced. It got new gaskets and fresh cool...
08/24/2026

Spark plug blew out and it could not be repaired. So the head came off & was replaced. It got new gaskets and fresh coolant & the damaged spark plug was replaced as the other 3 were ok.

ICE CREAM MAN FOR THE SAVE ON THIS HOT DAY
08/14/2026

ICE CREAM MAN FOR THE SAVE ON THIS HOT DAY

Flywheel took out the starter. Installed new flywheel, starter, rear main seal, and oil pan gasket(didn't get a pic).
08/13/2026

Flywheel took out the starter. Installed new flywheel, starter, rear main seal, and oil pan gasket(didn't get a pic).

Came in with a misfire at idle on cylinder  #5. Moved fuel injector, spark plug & ignition coil to oher cylinders & misf...
08/11/2026

Came in with a misfire at idle on cylinder #5. Moved fuel injector, spark plug & ignition coil to oher cylinders & misfire stayed on that cylinder. So we checked compression and was a little on the low side. So we pulled valve cover off to check valvetrain & at first we didn't see nothing out of the norm. But we had to bring out the mic to measure the cam lobes on that cylinder and found it to be .05 lower than one another, that was enough to cause a small misfire at idle. So we pulled the cylinder head & replaced it with a remanufactured unit. Also found timing chain guides a lil bad. So we put a timing chain kit while it was apart. Got her all back together and added an updated oilcooler & lower aluminum intake. Back to the trails it goes.

Truck expierenced an all neutral situation but we got him back up & going along with a new thermal bypass valve & a new ...
07/16/2026

Truck expierenced an all neutral situation but we got him back up & going along with a new thermal bypass valve & a new radiator. We also flushed all the transmission cooler lines befor new parts we installed.

Did the s&s dcr high pressure fuel pump conversion on this 6.7 powerstroke. We also replaced the fuel filters and back o...
07/16/2026

Did the s&s dcr high pressure fuel pump conversion on this 6.7 powerstroke. We also replaced the fuel filters and back on the road she went.

Address

1540 N. Temple Drive
Diboll, TX
75941

Opening Hours

Monday 8am - 6pm
Tuesday 8am - 6pm
Wednesday 8am - 6pm
Thursday 8am - 6pm
Friday 8am - 6pm

Telephone

+19362120538

Website

Alerts

Be the first to know and let us send you an email when Nutbusterz Garage posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share