Super Car Restoration

06/08/2026

Next up is body work. Scooter and James do what we call a “puddy rub” working the outer panels and blocking the car straight.

05/27/2026

The same attention to detail goes under the car. Here is the frame and some of the suspension parts that were body worked as well as the rear end housing. Because the rear end housing was original to this car, a lot of effort went into restoring it.

05/21/2026

More small parts reworked, here is the heater box, door hinges and oil pan.

05/14/2026

05/14/2026

It’s the details that bring these cars back to life. Each part, no matter how small, is hand worked to perfection.

05/12/2026

Prior to final fabrication the sheet metal is mockup to the body to ensure we have proper panel gaps and alignment.

05/11/2026

After the NOS quarter panels were welded into place, the roof to quarter seams were leaded in as they were originally.

05/08/2026

Brewster used a Gyspot welder to duplicate the original factory spot welds. A few sections were buttwelded in, saving as much of the original floors as possible, right down to the dropdown with original stamping.

05/04/2026

At some point the trunk floor had been cut out to allow for a fuel cell. The owners were able to source an original trunk floor to section in. A few small modifications were made to make the replacement trunk floor section period correct for this build date.