Jerry-Rigged Garage

Jerry-Rigged Garage Welcome to Jerry-Rigged Garage this is project Blasphemy �� s2000 full build in progress. Stay tuned for updates and diy's �

09/13/2017

Hello everyone, here is a quick update on what's been going on over at Jerry-Rigged Garage. Enjoy! 🍻

09/09/2017

Hello everyone got engine mounts finally set up and good to go working on the transmission mounts now. Here is a quick video of how the motor mount set up went for me, Enjoy! 🍻

09/07/2017

Hello everyone, here's a late night update on what's going on at Jerry-rigged Garage. I am installing the engine and transmission for mock up on the mounts. Here's a quick summary video of what I've been up to, enjoy! 🍻

Late nights in the garage. 👌🏽 So, I installed the pushrods and rockers in the engine yesterday. I used new trunion upgra...
09/06/2017

Late nights in the garage. 👌🏽 So, I installed the pushrods and rockers in the engine yesterday. I used new trunion upgraded rockers and thicker 7.4 pushrods. It is fairly straight forward, unfortunately I didn't get to record it. Simply place the pushrods into the heads on the lifters pushing them down so that the pushrods "push" the lifters down to make contact with the camshaft. Once they are in, you place the rockers over top with the rocker arm covers, and holding the pushrods with the rockers you bolt them down. I put a good amount of loctite on these bolts so that they hold well and so that there wouldn't be any air escaping the heads from the port job done. Torque them down to 22 ft/lbs I believe. Then simply place the valve covers on with their gasket of course and you are good to go the engine rebuild is complete. 🍻 Cheers

Hello everyone, the engine bay was prepped and ready for paint. I bought an awesome color for the bay to pop, but will n...
09/05/2017

Hello everyone, the engine bay was prepped and ready for paint. I bought an awesome color for the bay to pop, but will not be painting it legit... until the whole swap is complete and ready to run. So I can then pull one last time for the finishing touches with the final coats of paint. For now my good friend Mike Rod gave it a coat of primer for the mean time. Cheers 🍻

Big shout out to American powertrain, received my t56 magnum with the closed ratio 💪🏽 I am getting ready to install the ...
09/02/2017

Big shout out to American powertrain, received my t56 magnum with the closed ratio 💪🏽 I am getting ready to install the bellhousing and prep it for the car. 👌🏽 I need to get the BFH for the trans tunnel going to have a good time getting all my anger out.. haha Cheers! 🍻

09/02/2017

Hello everyone, here's a quick dent removal diy for simple quarter panel dents. Enjoy! 🍻

08/31/2017

Good afternoon everyone, here's yet another follow up on the intake shaving. Had a lot of fun editing this video. Haha Cheers! 🍻

08/30/2017

Hello everyone, here is another follow up on the intake manifold shaving process. Thanks for the support everyone, the build is starting to take shape little by little. Cheers 🍻💪🏽

08/29/2017

Now this is Jerry-rigged to the max 😅 enjoy 🍻

Address

Chicago, IL

Website

Alerts

Be the first to know and let us send you an email when Jerry-Rigged Garage posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category