Hammer’s Small Engine Repair

Hammer’s Small Engine Repair Small engine work. 567-429-9591

Hammerhead 250cc go kart. Main gears stripped out and wouldn’t move. Installed new gears and now it’s ready to ride.
09/03/2026

Hammerhead 250cc go kart. Main gears stripped out and wouldn’t move. Installed new gears and now it’s ready to ride.

Got to support the Bascom stumble inn golf outing this past Sunday. Sign turned out damn good.
08/18/2026

Got to support the Bascom stumble inn golf outing this past Sunday. Sign turned out damn good.

Cub zero turn. Only running on one cylinder. Left side ignition coil was bad. Replaced both.
08/06/2026

Cub zero turn. Only running on one cylinder. Left side ignition coil was bad. Replaced both.

2009 toro workman hdx 3 speed manual . Had to pull the steering cylinder off to have rebuilt. Had to take apart the enti...
07/24/2026

2009 toro workman hdx 3 speed manual . Had to pull the steering cylinder off to have rebuilt. Had to take apart the entire front to get to it.
Tune up/oil change.
Adjusted the emergency brakes.
New ignition coils.
Verified clutch was still good.
Pulled one of the spark plugs out and the threads came with it. Had to run new threads on the first cylinder.

John Deere x534. Would shut off after it gets warm. Thought it was the ignition coils. After doing some digging. Found t...
07/15/2026

John Deere x534. Would shut off after it gets warm. Thought it was the ignition coils. After doing some digging. Found this electronic control units go bad and causes it to stall.

John Deere 737. New seal for the oil filter housing. Had to pull hydro pump to Install seal behind main pulley.
07/13/2026

John Deere 737. New seal for the oil filter housing. Had to pull hydro pump to Install seal behind main pulley.

Had this Deere mower in. Found bent pushrods on the left side. Both valves were bad. Had a parts motor with good parts. ...
07/10/2026

Had this Deere mower in. Found bent pushrods on the left side. Both valves were bad. Had a parts motor with good parts. Swapped heads and she’s as good as new.

Had this coolster 120cc on for an idle problem. Fixed the steering wheel so it’s straight. Adjusted the drive chain tens...
06/05/2026

Had this coolster 120cc on for an idle problem. Fixed the steering wheel so it’s straight. Adjusted the drive chain tension. Fixed the key ignition. Oh fixed the idle issue. Was to low that it would die at idle.

Another Club car. 1990. Fixing leaking head gasket and installing a new muffler.
05/30/2026

Another Club car. 1990. Fixing leaking head gasket and installing a new muffler.

99 club car. Installed a new starter/generator. Was wore out and wouldn’t move the cart.
05/30/2026

99 club car. Installed a new starter/generator. Was wore out and wouldn’t move the cart.

Address

5920 West Tiffin Street
Bascom, OH
44809

Website

Alerts

Be the first to know and let us send you an email when Hammer’s Small Engine Repair posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Hammer’s Small Engine Repair:

Shortcuts

Share

Category