JLM Lubricants Asia Pacific Pte Ltd

26/10/2021

https://youtu.be/YkfWr_VouV8

JLM was established in 2010. Our laboratories, sales, marketing, and distribution centre are based in the manufacturing powerhouse of the Netherlands.Our mis...

26/07/2021

This product is intended for professional use only!

JLM has designed its Direct Injection Valve Cleaner for ease of use. Instead of requiring direct access to the cylinder-head inlet tracts, the product enters the air intake of a warm running engine, thus avoiding extensive dismantling.

Shake the aerosol for at least two minutes and direct the spray into the intake in small bursts not exceeding three seconds. Never allow the cleaner to pass through the intercooler, or enter any corrugated/convoluted rubber pipes, which can cause pools to accumulate. When you have decided the best access point for the engine on which you are working, proceed as follows:

1. Start the engine, ensure it is to its normal running temperature and run it at idle speed.
2. Spray the product in short intervals of up to three seconds into the intake manifold. The engine speed may increase, or decrease, with each application.
3. Allow the engine revolutions to stabilise before spraying again.
4. Should the engine speed increase, or you notice knock/pinking/pinging, cease spraying and allow the engine to return to idle. Do not depress the accelerator.
5. With half of the aerosol content used, allow the engine to idle for a further two minutes before continuing.
6. When the aerosol is depleted, allow the engine to idle for a further two minutes.
7. Stop the engine and reassemble the intake system.
Start the engine again and accelerate it to 2,500rpm briefly and allow it to idle again. Repeat ten times.
8. Alternatively, embark on a short drive of between 5-8 kms (3-5 miles).
9. Before stopping the engine, allow it to idle again for at least one minute.

JLM's Direct Injection Valve Cleaner should be used in a well-ventilated area; both gloves and eye protection are necessary.

02/12/2020

5W40 Premium Grade Performance Oil. ACEA C3, API SN/CF / BMW Longlife-04 / MB-Approval 229.51 / Porsche A40

02/12/2020

5W30 Premium Grade Performance Oil. ACEA C3, API SN / MB-Approval 229.51/229.52 / BMW Longlife-04

12/11/2020

BIMMERFEST VIETNAM 2020 is here again. And we are proud to be a part of it. 🤝