Motorized and ebike kit convertion

Motorized and ebike kit convertion This kit will allow you to turn your bicycle into a gasoline powered motorbike! 1 Gallon of fuel runs 150 miles!! The engine is designed to be pedal/chain

STEP 1
There are two rear sprocket rubber packers. Cut one of them and only one. Cut only between the drilled holes. STEP 2
Place the cut one inside of the spokes. STEP 3
Place the other packer on the outside of the spokes. STEP 4
Thread the nine bolts through the sprocket and use the half moon backing plates on the inside. Tighten all nine bolts moving across in a star fashion and a little at a t

ime to allow for an even pull down. Once the sprocket is tight spin the wheel and check that the sprocket runs true. Deviation can be no more than 1.5mm both ways. Any side-to-side excess deviation can be corrected by spinning the wheel and then tightening the sprocket where needed in order to get correct alignment. Make sure bolts are tight. Notice that concavity or indentation of teeth of the rear sprocket is inward towards spokes. This helps keep the chain closer to the inside of the wheel and spokes and allows for better clearance of the rear stays of the bicycle frame.

Address

Road 23 Project 8
Quezon City
1106

Telephone

09079140003

Website

Alerts

Be the first to know and let us send you an email when Motorized and ebike kit convertion posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Motorized and ebike kit convertion:

Shortcuts

Share

Category