08/08/2026
😃 🚘 USE OF THE MIRRORS 🚘 😃
(This is a long post but worth a read to learn all about the mirrors)
Lots of people / pupils underestimate just how important the mirrors are to a driver and how regularly We should be checking them when driving and also when and which ones!
It can be confusing to a new beginner, but if you read my post on the mirrors below, you should begin to understand the importance of checking them regularly and understand why We check certain mirrors at particular times.
THREE MIRRORS
There are three mirrors on the car. One inside and then two outside on each door. They are referred to as the interior mirror and then the exterior left or right mirrors for the ones on the doors outside the car.
These are fully adjustable from inside the car. Back in the old days, you had to open the window and physically reach out and adjust them but now the majority of modern cars have electrically adjustable mirrors which are adjusted via a four way switch on the dashboard or on the car door near to where the electric window switches are.
The interior mirror should allow for a clear view out of the rear window (not too much back seat or roof of the car visible) and this is on a pivot and can be easily adjusted by hand to suit your view into it from a normal driving position.
The exterior mirrors are set so that We get a nice view of the road behind us without seeing too much of the sky or the actual road surface. If you set them too low, you will see lots of movement in them as the road surface zooms by underneath us. The view in the exterior mirrors should be fairly level when the car is moving along. This shows that they are correctly adjusted.
If mirrors are set too low then it can be quite distracting to the driver and you may not even realise what it is that you are seeing out of the corner of your eye until you become aware of it.
We do tend to tilt the left mirror down ever so slightly, just so We can use it to judge the kerb position next to the car when pulling up on the left. This is to help avoid dragging the tyres along the kerb edge or scraping the wheels when parking. Tyres are only made of rubber, which is a few millimetres thick, and a hard hit on a kerb edge can easily pop a tyre! So, We try and avoid that where possible and use the left mirror to guide us in and position just under a drains width when pulling up on the left to park.
For the reverse bay parking manoeuvre, We can (and usually do) tilt both mirrors down so We can see the lines on the ground to help guide you into the bay. You are allowed to do this on your driving test, but you must remember that if you do, you must put them back up when the manoeuvre is complete or you could get a fail for driving along with mirrors which are basically unusable which is obviously a safety issue!
You do not need to put the mirror down for the parallel parking exercise or the right-hand move off exercise.
CONCAVE OR CONVEX
A mirror can be Concave or Convex and the image can vary depending on what type of mirror your car has.
A concave mirror makes the image size smaller, and a convex mirror makes it appear larger. Most car mirrors are concave, especially the door mirrors.
MIRRORS IN PAIRS
When We check the mirrors We generally check them in pairs. Interior first and then the relevant side mirror depending on which direction We are taking.
So if you are turning left at a junction you would check the interior mirror first to see what is directly behind you and then the left mirror for a slightly wider, but smaller view of your road position and any cyclists if you are in slow moving traffic.
MIRRORS FOR ROAD POSITION
To see where the car is positioned on the road when you are driving, you generally check the left mirror to see where the kerb is or the white line that runs along the edge of the road. You can also use the right mirror to see where the centre dotted road markings are and then get a balance between both mirrors. When We drive along a road, We normally have a slight offset to the left to keep us away from the centre of the road. So basically, the gap on the left should be slightly smaller than the gap on the right.
IMAGE SIZES
There is a marked difference in the sizes of the images that you see when you compare the interior mirror to the left door mirror. We look at this on our first ever lesson when you do your cockpit drill and controls and I will make a point of getting you to look at something behind us, usually a parked car or a bush or something and comparing the sizes of what We are focusing on.
THE TRUE IMAGE
The interior mirror on most cars is a standard mirror and is usually a flat piece of glass. So what We see is a true reflection in size to what We see in real life. So We refer to that view as the 'true image'
The exterior mirrors do give a nice wide view of the pavements and any driveways, but the image size in comparison to the interior mirror is around half the size.
WHEN TO CHECK
Mirrors should be checked on approach when We turn into junctions and approach roundabouts, when changing direction (going around parked cars or a bus that is stopped at a bus stop) and when increasing or reducing speed and when approaching a hazard of any sort which may cause you to reduce speed including traffic lights and pedestrian crosssings.
WHAT TO CHECK FOR
We check the mirrors to see if what We are about to do will affect anyone who is behind us.
Also, when We brake to a stop or slow down, it's good practice to check that the car following you is responding to your brake lights and also slowing down.
There could be emergency vehicles and We might have heard a siren but may not be certain whether that vehicle is approaching from in front or if its behind us. By checking the rear view mirrors, you will soon be aware of if it is behind you and you can then take any evasive action needed.
THE ROUNDABOUT DRIFT
When you are going third right on a roundabout, you will generally be doing that from the right-hand lane or at least a right-hand position.
When the time comes to leave at your junction you will then be changing lanes or position back to the left so you MUST check the left mirror before you start your left drift to make sure that there isn't another car in the left lane which could create danger if there was.
This is one of the more common faults on a driving test and can result in a serious or dangerous fault on the test if no attempt is made to check the left mirror before signalling and then drifting to the left.
HOW OFTEN
Things are changing constantly behind us, so We need to 'update' regularly. As a rough guide for driving test, your examiner will be expecting a mirror check about every 15 to 20 seconds. So that is three or four times every minute, and it's good practice to do those checks in alternating pairs. Interior then left and next time interior then right and make them nice and obvious too so the Examiner is in no doubt that you are checking them.
DUAL CARRIAGEWAYS
When driving at high speed on a motorway or dual carriageway you need to be constantly checking for vehicles behind who are catching up and overtaking and also checking the right mirror for the possibility that if you need a sudden lane change then it's safe to do so. This is very important when approaching a joining filter lane / slip road.
Also if you are being held up by a slower moving vehicle and feel the need to do an overtake then you will need to be checking the right mirror for either a space to move out into or to assess any cars from behind and making a decision as to when it will be safe to move out into the right lane.
The car does have a blindspot monitor as one of its many safety features and when a car approaches us from behind and is just about to overtake, an orange light will come up in the mirror to warn you that they are there.
These are just a few examples of mirror use, and We will go through all of these and more on your lessons.
I may add more to this post every so often, so if you see it a few times in your feed, then I have probably done an update......
Darren 😃
Driving Force 🚗💨