What are the opening hours?

Monday 8:30am - 6pm Tuesday 8:30am - 6pm Wednesday 8:30am - 6pm Thursday 8:30am - 6pm Friday 8:30am - 6pm

https://www.facebook.com/2076831309275411/

Metal Head Fabrication

Home
United Kingdom
Callington
Metal Head Fabrication

Call Directions Contact the business

Automotive restoration, modifications and Motorsport fabrication

28/10/2026

Supplied brother Ben some workshop upgrades now that he's taken over ownership of Liskeard MOT Centre.

A nice sturdy work bench with an oil drainer trolley that slides under, designed for a 20L drum to fit inside so fluids such as diff oil or power steering fluid can go straight in.

A gas bottle cage, because those health and safety audits exist.

Finally, a set of ramp extensions so he can fit low cars onto the alignment ramp.

So for all your servicing, repairs and MOTs go and see brother Ben

Ben Byrne

11/08/2026

As always, I'm way more active over on TT, so please head over and give the page a follow if you use that platform 😎

21/07/2026

BMW 2002 back end work.

Boot floor and rear valance replaced, rear inner arches and upper suspension mounts repaired. Everything epoxied, seam sealed, undercoated with winter grade epoxy coating, then inside of the boot, rear quarter panels and back end repainted.

This one will be back in the winter to tackle areas of the front end, roof and doors.

It was a pleasure to work on this car, these are the kind of cars that are the reason we opened our doors in the first place.

Videos of this job and many others can be found on Metal Head's TikTok page, which can be found here:

https://www.tiktok.com/?_r=1&_t=ZN-98E6gsKGMgI

02/07/2025

I never get around to posting on all of my socials pages properly, but I've been doing a bit on TikTok lately. Go and check it out! I enjoy making the step by step videos, and always appreciate follows, likes and comments 😎

1348 Followers, 40 Following, 9133 Likes - Watch awesome short videos created by Metal Head TV

21/05/2025

Alfa 156 rear inner and outer arches plus a full repaint. All finished off and ready to go back to the customer tomorrow!

17/01/2025

A bit of a tricky one on this VW Transporter this week!

The front strut tower had been very poorly repaired in the past, so the only option was to replace the whole thing.

A jig had to be made that bolted to the bulkhead, chassis leg and strut tower to ensure that when the new one was fitted it would be in the exact same place to keep the suspension geometry as it should be.

The job started with removing the new strut top from a cut that was supplied by the customer from another van. Then the same job then had to be done again to remove the rusty strut tower. Once that was out of the way there were one or two small repairs to do, then all edges and flanges were weld primed ready to fit the new tower.

A bit of wiggling and persuasion later, and the new tower is in ready to be seam sealed.

On to the next job!

08/01/2025

Starting to get the Commer coated with epoxy. Section by section for now, then the real bodywork begins once the whole van has a base layer to work from.

29/12/2024

Jaguar XK8 rear wheel arch/quarter panel/inner arch repair/replacement.

Sent to us by STM Bodyworks and went back to them for paint after our work was complete 😎

09/12/2024

Jag X Type in last week with a very poorly NS sill.

All finished off and ready to head up the road to STM Bodyworks to be painted.

22/11/2024

Mini Cooper S underside restoration well under way this week.

Looking forward to reassembly next week!

Address

Unit 9 Pinnacle West Business Park
Callington
PL177FF

Opening Hours

Monday	8:30am - 6pm
Tuesday	8:30am - 6pm
Wednesday	8:30am - 6pm
Thursday	8:30am - 6pm
Friday	8:30am - 6pm

Telephone

+441579551115

Website

facebook.com

Alerts

Be the first to know and let us send you an email when Metal Head Fabrication posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.