Almost Oldschool

06/19/2026

Recently finished to this wild snake resin sissybar and a few other pieces for Jesse James shovelhead.

I frenched in a LED strip in the frame so when the Prism Supply brake light turns on it also lights up the resin and snake. I also hid a connection under the seat so he can power the LEDs while the bike is off at shows which you may have seen Party At The Pen. I machined the top spikes to match the his spiked fork tube caps he has on the bike to blend front to back if the bike.

The base layer of resin was tinted blue to match the paint with the snake laid in clear resin to light up nicely, done by 𝕽𝖔𝖔 𝕸𝖔𝖗𝖗𝖎𝖘𝖔𝖓

Made up a clean and simple primary mount lisence plate bracket and machined some flush stainless hardware to hide holes in the fender from where a pilion pad was that I removed.

06/11/2026

05/05/2026

Last sneak peak of my panhead build for before the show!
Come check it out next weekend!

05/02/2026

killed it on this mud flap for the shovel! Thanks again dude!

04/27/2026

Some custom Lee style high pegs for shovel build

04/17/2026

Cool little sissybar headed out east to for his Softail build. He's running a big one riser set up so this sissy matches the squared look well

04/16/2026

Quick exhaust fix on this Bassani pipe for an Evo. The factory spot tacks had no pe*******on causing the end to pop off mid ride for the customer. New rosette welds all around and a few stitches on the outer edge for good measure.

04/12/2026

Some stainless shafts I made for a local business. These had a tight tolerance to slug into SCH 80 pipe I welded them into on one end and to match motor and bearing bores on the other to keep everything concentric. Motor shafts were finished off with a keyway slot and threaded ends.