GreerCo Equipment & Truck Repair

08/26/2023

We are excited to share with you our latest venture @ GreerCo Equipment & Truck Repair!

We now offer tilt and load float / flat bed service as well as boom truck service!

Call us for your equipment and material moving and lifting needs.

613-218-3108

03/08/2020

Just a wee bit of slap going on here...

02/09/2020

Its not every day you get to work on a 1904 Sail Boat "The Black Jack" We had to remove the propeller, and push the very long and heavy drive shaft from the inside of the boat out. Then we removed the old through hull bearing and installed a new one. We also installed a new driveshaft. We then re installed the prop.

A proud moment when completed

02/09/2020

We slid this large beam through the exterior wall into a classroom. Slid up against the underneath of the second floor to allow for the removal of a load bearing wall to make two classrooms in to one.

02/09/2020

Rebuilding a manure agitator. All stainless steel components minus the pulley

02/09/2020

The hydraulic valve had a bad leak between the sections. We removed it and re sealed it.

02/09/2020

02/09/2020

To my knowledge this engine has never been apart. Heads of the head bolts were almost gone from age. Re sealed top end and new head gasket....

02/09/2020

Checking over the machine, we found the right chain case had over 60L of water in it. A result of the chain case being previously repaired. The chain case was not straightened then welded causing a large gap between the axle housing and chain case. Some one had filled the gap between the axle housing and chain case with silicon (to fill in the uneven gap) which never sealed . Water over time went in the crack and filled the chain case

02/09/2020

C12 Cat came in looking like a smoking steam train, It had a cracked head and cracked injector

10/19/2018

Busy day @ the shop