BILLTECH AUTOMOTIVE

BILLTECH AUTOMOTIVE - Rego Inspections
- All Mechanical Repairs
- Performance Work
- Engine Building
- Dyno Tuning MECHANIC

Noah's vl came in to wire up a haltech,  fab, little fuel system and tune making 210hp through the auto
11/06/2026

Noah's vl came in to wire up a haltech, fab, little fuel system and tune making 210hp through the auto

10/06/2026

Some in car footage of going down the track engine built by until next time

10/06/2026

Taking rx3 to the track first pass bombing the tyres running 9.2@158 . With a better 60 and hooking up will run deep in the 8s

This rx2 came in for a service and tune make 162hp NA running a haltech ecu
10/06/2026

This rx2 came in for a service and tune make 162hp NA running a haltech ecu

09/06/2026

We all love buying new car parts😬❤️

08/06/2026

This is what 11,000 horsepower does to a top fuel dragster tire at launch! And the speed record was set on October 2, 2022 by Brittany force! She went 338.48 mph in her Flav-R-Pac dragster in the opening round of the NHRA Midwest Nationals at the World Wide Technology Raceway! BullSnot proud driver!

TOP FUEL ACCELERATION FACTS!
* One Top Fuel dragster 500 cubic-inch Hemi engine makes more horsepower (11,000 HP) than the first 5 rows at the Daytona 500.
* Under full throttle, a dragster engine consumes 1.2-1.5 gallons of nitromethane per second; a fully loaded 747 consumes jet fuel at the same rate with 25% less energy being produced.
* A stock Dodge Hemi V8 engine cannot produce enough power to merely drive the dragster's supercharger.
* With 3000 CFM of air being rammed in by the supercharger on overdrive, the fuel mixture is compressed into a near-solid form before ignition. Cylinders run on the verge of hydraulic lock at full throttle.
* At the stoichiometric 1.7:1 air/fuel mixture for nitromethane the flame front temperature measures 7050 degrees F.
* Nitromethane burns yellow. The spectacular white flame seen above the stacks at night is raw burning hydrogen, dissociated from atmospheric water v***r by the searing exhaust gasses.
* Dual magnetos supply 44 amps to each spark plug. This is the output of an arc welder in each cylinder.
* Spark plug electrodes are totally consumed during a pass. After 1/2 way, the engine is dieseling from compression plus the glow of exhaust valves at 1400 degrees F. The engine can only be shut down by cutting the fuel flow.
* If spark momentarily fails early in the run, unburned nitro builds up in the affected cylinders and then explodes with sufficient force to blow cylinder heads off the block in pieces or split the block in half.
* Dragsters reach over 300 MPH before you have completed reading this sentence.
* In order to exceed 300 MPH in 4.5 seconds, dragsters must accelerate an average of over 4 G's. In order to reach 200 MPH well before half-track, the launch acceleration approaches 8 G's.
* Top Fuel engines turn approximately 540 revolutions from light to light!
* Including the burnout, the engine must only surviv

08/06/2026

Its been a good 10+ years since we've taken the OG shop car down the quarter mile. . It's still in her. Who wants to see her back out on that start line?

05/06/2026

Andrew VS snapon ratchet test 🤣

Jeds vl came in for wiring in the haltech setup,  turbo upgrade,  fuel system,  fab,  and a bunch of other things now co...
05/06/2026

Jeds vl came in for wiring in the haltech setup, turbo upgrade, fuel system, fab, and a bunch of other things now coming off the dyno making 600hp through the jatco

02/06/2026

came up from Melbourne to tune his rx2 making 940hp through the auto running one of 13b bilet engine and haltech catalogue 💪💪

Address

83 Clapham Road Sefton NSW
Regents Park, NSW
2162

Opening Hours

Monday 8:30am - 5:30pm
Tuesday 8:30am - 5:30pm
Wednesday 8:30am - 5:30pm
Thursday 8:30am - 5:30pm
Friday 8:30am - 5:30pm

Alerts

Be the first to know and let us send you an email when BILLTECH AUTOMOTIVE posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to BILLTECH AUTOMOTIVE:

Share