What are the opening hours?

Monday 7:30am - 4:30pm Tuesday 7:30am - 4:30pm Wednesday 7:30am - 4:30pm Thursday 7:30am - 4:30pm Friday 7:30am - 4:30pm

Port Macquarie Automatics

Home
Australia
Port Macquarie, NSW
Port Macquarie Automatics

Directions Website Contact the business

Automatic Transmission Specialists
As well as CVT, DSG & Dual Clutch Transmissions
Servicing & Repairs

12/10/2026

TRANSMISSIONS AREN’T FILLED FOR LIFE!

Despite what you might have been told, automatic transmission fluid deteriorates over time and needs servicing to help keep your transmission operating at its best.

And remember! — replacing the fluid won’t fix an existing fault! If your transmission is slipping, shuddering or shifting incorrectly, proper diagnosis is the first step.

06/10/2026

Before the holiday road trips and the heat hit, give your car's transmission some attention.
At Port Macquarie Automatics, we can help with:
🔧 Transmission services
🔧 Automatic transmission repairs
🔧 External oil cooler installation
🔧 Heavy duty Valve body upgrades

Hot weather, towing and long drives put extra strain on your transmission. Adding an external oil cooler helps keep transmission temperatures down, protecting your gearbox and giving you peace of mind on the road.
📅 Book in early before we fill up for the Christmas rush!

📞 Phone: 02 6584 3466
📧 [email protected]
🌐 www.pmqautomatics.com.au
📍 11 Newport Island Road, Port Macquarie

09/09/2026

Today’s job is another Holden Commodore 6spd 6L45 automatic, fitted in both VE & VF V6 in the workshop with a transmission fluid leak from the front of the transmission.

This type of leak can commonly be mistaken for a front seal leak, so proper diagnosis is important before pulling anything apart.

Once the vehicle was hoisted and inspected, we confirmed it was transmission fluid leaking from the front of the transmission. The transmission was then removed for further inspection.

We pressure-tested the torque converter and found a crack along the torque converter throat, which was the source of the leak.

We replaced the failed torque converter with a quality reconditioned unit.

While the transmission was out, we also gave the customer the option to replace the pressure regulator valve in the pump. This helps address wear that can contribute to the dreaded torque converter shudder and can help prolong the life of the replacement converter.

16/06/2026

Today's repair involved a Volkswagen / Audi DSG transmission with a faulty Transmission Control Module (TCM).

The vehicle presented in limp mode and clutch performance issues. After diagnosis, we found the TCM was incorrectly reading clutch pressures on Clutch 1, in the data clutch 1 specified pressure was 0 bar but actual was reading -.67 bar, causing the transmission to operate outside of its intended parameters.

The good news is that in many cases, we can replace the Transmission Control Module without replacing the complete mechatronic unit, providing a much more cost-effective repair option for our customers.

Accurate diagnosis is key with these complex dual-clutch transmissions, ensuring the right repair is carried out.

11/06/2026

A Job we had recently was a VW Polo fitted with the DQ200 DSG transmission, suffering from clutch shudder.

This is a common issue caused by wear in the dual clutch assembly, often resulting in vibration, shuddering, and poor drivability.

After diagnosis, the transmission was removed and the clutch assembly replaced, restoring smooth operation and driving performance.

09/06/2026

Today's transmission teardown revealed a major issue with the reverse clutch pack in a Toyota Prado A750 transmission.

The reverse frictions had completely fallen apart, sending friction material throughout the transmission and blocking the filter, restricting oil flow. For reference, the bolt shown highlights the excessive clearance we found in the clutch pack.

The reverse clutch air gap measured approximately 6mm when specification is around 1mm, explaining the poor operation and internal damage found during inspection,

Transmission overhaul required.

05/06/2026

Today’s job was a Toyota Hilux fitted with an A343F automatic transmission that came in with torque converter failure.

Once the transmission was removed and disassembled it was thoroughly cleaned and inspected, the only reliable repair was a complete transmission overhaul, including replacement of the failed torque converter with a new one as it couldn’t be reconditioned, it also needed a new pump, the stator surface machined up, and a new radiator as the cooler was full of metal.

04/06/2026

Did you know we make our own heavy-duty Ford Ranger / Everest / Mazda BT50 6R80 transmission cooler kits. Suits 6 speed auto
2.2L & 3.2L turbo diesel models

Our kits feature thermal by pass valve, durable metal hard lines and a large single-core transmission cooler designed to help keep transmission temperatures under control, especially when towing, carrying heavy loads, or operating in harsh Australian conditions.

Lower transmission temperatures can help improve reliability and extend the life of your transmission, making a cooler upgrade one of the best preventative modifications you can make to your 6R80-equipped vehicle.

21/05/2026

Today’s job — Ford Fiesta 6DCT250 dual clutch replacement

This vehicle came in with a transmission warning light illuminated and would almost stall when selecting drive or reverse.

After carrying out diagnostics, we found the transmission was only operating in 1st, 3rd and 5th gears. The vehicle also had a noticeable clutch drag when coming to a stop — a common sign of clutch issues in these transmissions.

The transmission was removed and the dual clutch assembly replaced, restoring proper operation and drivability.

07/04/2026

One of today’s transmission services,
Nissan CVT

Did you know most of these transmissions actually have 2 filters?

✔️ One located under the transmission pan
✔️ One in the cooler return circuit

Both play a critical role in keeping your CVT running smooth 👍

Address

11 Newport Island
Port Macquarie, NSW
2444

Opening Hours

Monday	7:30am - 4:30pm
Tuesday	7:30am - 4:30pm
Wednesday	7:30am - 4:30pm
Thursday	7:30am - 4:30pm
Friday	7:30am - 4:30pm

Website

http://pmqautomatics.com.au/

Alerts

Be the first to know and let us send you an email when Port Macquarie Automatics posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Port Macquarie Automatics:

Want your business to be the top-listed autos & automotive service in Port Macquarie?