Kays Fabrication

21/12/2025

That was an eventful day out at QR for the Sleigh Day. We started the day with a dead alternator then after repairing that I ran over a crash bar. Ended up getting jammed under the car and it punched a 50c size hole in the gearbox casing. We decided to get the welder out and repair it. Managed to get out and enjoy the last few hours of the day. Massive thanks to from for helping me get it done

13/12/2025

Sneaky 4th gear pull on the exit of the back straight chicane at GC500. Back at it next weekend at Queensland Raceway for the Sleigh Day on the 21st from 9am


 
 
 
 
 
 
 
vault 
 
 


media 📸

08/10/2025

Three wheelin









vault

06/10/2025

A bit of testing at Morgan Park with yesterday. We made some fixes after WTAC, where we had a rear wheel bearing collapse and kept losing the hand brake because the pads were pushing back into the caliper.
Big thanks to for allowing me to take the rod out and get some testing in before GC500.








vault

27/03/2025

Some may have wondered what had happened to Levi's S15. Well I'm happy to announce its undergoing a full birthday for the Clarke family. With the help of a few key people the wheels have started to turn on getting this running again!

stopped making manifolds over 3 years ago but had always promised Levi a new manifold when needed and held that promise to ensure the S15s new turbo setup was good to go.
The new Garret G series now sits on a larger 40nb promod style manifold with a 60nb crossover pipe and single 60mm waste gate and fresh EGT sensor ports.

The engine has now been removed with the help from and will be on its way to at

Over the next few weeks the engine bay will get a fresh lick of paint and the wiring loom will be repaired / replaced after it had been through a couple of fires over the years.

I'm looking forward to sharing more updates with everyone as the car gets a major overhaul

18/12/2024

New 5" exhaust for the SCS Motorsport 20B race car. Back to Pac Performance for a touch up on the tune next year

09/10/2024

Happy to be a part of this build helping Aaron get it over the line and ready for its tune. Can't wait to hear it ripping around Morgan Park
SCS Motorsport

05/09/2024

A huge couple of days filled with emotions and nervousness at as I was asked to pilot Levi's drift rod by the Clarke family.

A car I had practically no seat time in on a track I had never driven was a big task. I hope everyone enjoyed watching it. The people that were able to help make this happen, I can't thank you enough.










https://www.instagram.com/p/C_iJSxjpLlK/?igsh=MXZid3YwZXlqNjB1MA==

07/07/2024

I normally don't share gofundme's but this one hits close to home. It would mean alot if you can make a donation no matter how small it is

On the 9th of August 2022, after dealing with severe headaches … Hannah Fynn needs your support for Help support Levi & his family as they battle Brain Cancer

02/07/2024

Bit of a tricky one on this Renault Megane ecu. Soldered wires to both sides of the board and also bridged a few points to be able to read/write to it. All back together this morning and ready for the customer

12/04/2024

Alloy fab work on the SCS Motorsport billet 20B RX7 race car. Paddle shift Hollinger with every sensor you could think of including a steering angle sensor. Can't wait to see the times this one does!

17/03/2024

Big block HJ exhaust nearing completion