Jeeps R Us

01/09/2026

If it’s been leaking replace the tube and don’t use silicone as a permanent fix as it damn near blocked the bypass port on the water pump , this fix nearly cost the owner an engine 😡

30/08/2026

Shop will closed tomorrow as it’s my Birthday & for a present I get to start Radiation Therapy on my bean head 🤣we will be back on deck Tuesday so please leave a message if you need anything & we will get back to you as soon as we can Tuesday, until then Jeeples✊✊

18/08/2026

To our amazingly sneaky daughter Erin Cluley who has organised this for us , you truly are one of a kind & we can’t thank you enough being by our side ❤️

Hey everyone, we’re Erin and Trav Cluley. Richard is Travs dad, and … Erin Cluley needs your support for Richard’s Fight: Cancer vs One Very Stubborn Mechanic

05/08/2026

If Anyone is in need of a service , I have an open slot in the morning due to a late cancellation so if the morning suits please drop me a message or call 1st thing in The morning , I’m at the shop from 6am because waking up at 4 am is apparently normal 🤣🤣& the Door is open @ 7am 🙏

02/08/2026

Good morning champions , the shop will be closed to day for the Start of Round 3 on my Chemo side quest ✊shall be back on deck tomorrow to take bookings so please leave a message ‘ I’ll get back to you ASAP , Have a great day Jeeples ✊✊

19/07/2026

Unfortunately we are closed today sorry for any inconvenience this causes.

14/07/2026

I think I found the Truck that would maybe & im saying maybe out of a Ram but highly doubtful 🤣🤣this is absolutely Mint though 🤟

12/07/2026

Good morning my Jeeples , the Shop will be closed today as Round 2 of my Chemo Side Quest starts today , will be back tomorrow as normal with my mate Merv attached, please leave a message if you call & I’ll call you back 1st thing in the morning ✊✊have a great day champions 🤟

09/07/2026

When you install 9inch dinner plates and wire them up directly with a switch hidden under the bonnet & the AMP draw far exceeds what the factory harness & HI-Beam drive module can handle & burns out the D3S HID Globe & then kills the Headlight , I was actually ready to disconnect the feed harness to the light as I was testing inputs & outputs from the TIPCM for the Headlamp levelling system which was the only DTC , my Trusty office Boss & wifie Lisa Cluley asking questions & learning what pi**es me off when stuff isn’t done right 🤣🤣🤣asked what harness goes to the Headlamp so I grabbed it & disconnected it and BOOM one totally torched Power feed pickup the Kings lights are using for a trigger pickup ✊✊✊issue found , big harness repair, removal of the spot light harness & a new Headlamp assembly ✊✊