SG Fabrication

29/08/2026

Passenger side floor mat mounted in and door jam all smoothed out and in epoxy. Onto the drivers side 👍

26/08/2026

Give Liam a call for all your machining needs 👌

https://www.facebook.com/profile.php?id=61593653916036

CNC & Manual Machining
General Engineering | One-Offs | Production Runs

18/05/2026

Clean fit up 🤩

17/05/2026

I’m going to be running a Holley Dominator ECU and looking for a clean keypad style control setup for all my switches (ignition, start, blinkers, wipers, fans, pumps, boost, etc.).

From what I can see:

-There is no current Holley CAN keypad
-Most (Haltech, MoTeC, AiM) don’t integrate with Holley CAN
-This leaves either hardwired inputs or an external control system

What are people that use Holley actually using? Can anyone point me in the right direction?

Whatever the solution, it needs to be a clean install, reliable and not overcomplicated. I’m trying to keep it simple but still tidy and functional.

Keen to hear what setups people are running.

07/05/2026

Tonner rear chassis mods.

03/05/2026

Bolt in tunnnel finished and I’m super happy with how it turned out. Next up finish the dash and start on dimple died false floors.

11/04/2026

Mucked around fabricating a one off shifter perch that fits my reach and height perfectly. Trialed my new Vevor hydraulic hole punch and composite dimple dies which worked awesome. It will come in handy for the false floor, that is next on the list to do.

27/02/2026

27/02/2026

Finally got a few jobs done on the Tonner. The cowls been in bare metal for 8 years and now has a couple of coats of epoxy, thanks to and their Anti Ox and Easy Phos for keeping it rust free for that time. Roll cage has been 3/4’s finished for 6 years and now the intrusion bars, seat mounts and chute handle mount are done and will be going to the powder coaters next week.