SEAL Fabworx

16/10/2026

Had Darryl Miles Hq in to make the custom 2 piece wheels fit. This included extended wheel tubs, install the Magnum suspension coilover conversion, shorten the 9inch diff, new chromoly arms and some minor rust repairs.

13/09/2026

14/08/2026

From a cardboard idea to a 3d printed part to check fitment to billet

07/08/2026

Recently had Jay's Capella in for alot upgrades/ repairs to pass engineering after being built in South Africa. Including repairs to inadequate welding on the diff, repair chassis rails that was tearing off the body, new fuel fuel cell/battery box paired with new fuel lines. Moving forward a new adr approved momo steering wheel with a horn that now works. 12v heater demister installed by Ryan Lee from Rt Racecraft. Removal of "line locker". Raise the ride height to meet regency requirements. Plum back catch can so it no longer vents to atmosphere.

10/07/2026

Just a few 4link bars welded out this morning

01/05/2026

Nice way to start off a Friday with a fabricated ali radiator hose going off customer supplied template

24/04/2026

Had Nigel's hq in to add adjustment to the standard triangulated 4 link. Which then escalated to a new diff housing and parallel 4 link setup with new body mounts

25/02/2026

Every now and then something different comes through the door. Aaron's sidecar came in for mounts on a new pwr radiator. The attention to detail on the rebuild on this almost too nice to get dirty .

21/02/2026

This week's job to finish off, tubbed to rail, shorted borwarner diff, new lower brackets, coilover mounts and mount fuel cell

06/01/2026

Nice first little job finished for the start of a busy year. New headlight setup and new gear lever end machined in-house for Johns dirt side car.