Five Ten Customs

31/05/2026

Custom grill made for a custom Bedford van, replacing the stainless grill that was made in the 70s from curtain rods that's now all pitted and rusted out, this polished aluminium grill will keep it looking fresh. Next week itll be fitted ready for cars an coffee👌👌

31/05/2026

Nissan Urvan fuel tank all fitted up by the customer, happy to have it back on the road after constant trouble with rusted out tanks, made with extra volume for longer trips👌👌

31/05/2026

Some steel work today with some work to this 1jz turbo manifold by modifying the fl**ge to suit the turbo also welding a v band to the hot side to get it ready for a custom dump pipe🔥
Dragged the trusty mig welder out aswell this arvo to make a custom towbar for a drag challenge hk, should clean up nice after a quick wire wheel👌👌

26/05/2026

More work finished off for a epic procharger VF Clubsport, intake all complete with twin turbosmart bov, flushed welds for a seamless look and hd clamps on both ends.
Coolant hardlines all welded up and radiator mounts and fittings all done aswell👌👌

25/05/2026

Bit of work on the rotator today making up this inline filler neck for a big turbo VL commodore. Made with aeroflow fittings and end caps with a quick polish at the end to tidy it all up before its fitted👌👌

25/05/2026

Inline filler neck for a big turbo VL commodore, quick polish up makes the dimes shine🔥

Send a message to learn more

24/05/2026

Fresh new fuel tank for a 72 VH Valiant 318 V8 slightly more capacity than standard for the longer trips, and new straps made so it can be bolted back in the factory location. Nothing wrong with the original, the customer had just always wanted an alloy tank👌👌

19/05/2026

Busy lately with a range of different projects, custom radiator thermo shroud for a HG Holden. Neat brush look coil mount for a v8 Ford Cortina. An dash fitting conversion for a HK Prem radiator and a heater hose blank off for the water pump, and a couple of stainless fl**ges welded to flex bellows for an insane VF Clubsport build👌👌

18/05/2026

Brake fender bracket for a Harley now has a matching pair, new tabs on the blank bracket mirrored and machined to match and the bolt on bracket cut out threaded an polished👌👌

16/05/2026

308 Holden manifold in to have the top half all finished off after getting port matched, its going to look good poking out the bonnet once its fitted👌👌