Panda Built

Panda Built Full Drift/Race shop specializing in the LS platform.

Just because you thought you could fix it, doesn’t mean you should
09/06/2024

Just because you thought you could fix it, doesn’t mean you should

Freshly installed a Donovan Tarps roll up on this quint axle Sterling dump truck.
07/11/2024

Freshly installed a Donovan Tarps roll up on this quint axle Sterling dump truck.

The new owner brought me this car with a suspected fried Holley Hp after having blown up on the p/o. While diagnosing I ...
05/01/2024

The new owner brought me this car with a suspected fried Holley Hp after having blown up on the p/o.
While diagnosing I realized this whole car was wired with Posi-Lock connectors with tons of excess wiring and mixed lengths/sizes/colors of wire in a single circuit.

We removed the arc board, and built a new harness front to back with front and rear fuseboxes. We utilized the rest of the Holley HP’s I/O to not only control 2-step/launch, but to also control the trans-brake in the 2 speed glide for fully adjustable bump/smooth staging within the holley software.
The HP is controlling the trans-brake, bump, fuel pump speed, and twin Mac valves for co2 dome pressure control. Unfortunately having run out of i/o the engine and trans cooler fans are/will be ran by fluid thermostat switches.

With the new engine installed and plummed, reusing the original turbo kit and the tune adjusted, this SN95 should have no problem putting down some bus lengths.

Made lots of progress on the S13, front clip fully removed, most of the sound deadening is removed as well as damaged br...
10/25/2019

Made lots of progress on the S13, front clip fully removed, most of the sound deadening is removed as well as damaged bracing to be replaced by DOM hopefully soon.
Next step, a good powerwash, Roll cage and tube front.
@ Newport, Minnesota

The shop is finally clean, new lights installed, fab table completed and the new project S13 already has a major oil lea...
10/08/2019

The shop is finally clean, new lights installed, fab table completed and the new project S13 already has a major oil leak

Completed my first set of S14 cut knuckles today. Now just needs to install them and test his new angle.
08/01/2019

Completed my first set of S14 cut knuckles today. Now just needs to install them and test his new angle.

The Supra officially has a 1.5jz in and ready for dressing.
08/01/2019

The Supra officially has a 1.5jz in and ready for dressing.

Got the super old 1920s lathe cleaned up. Time for a motor and speed control, and to find some tooling for it.
04/30/2019

Got the super old 1920s lathe cleaned up. Time for a motor and speed control, and to find some tooling for it.

Got the pleasure of welding some Stance Coilover sleeves on Z31 knuckles today. Can't wait to see them installed.
04/20/2019

Got the pleasure of welding some Stance Coilover sleeves on Z31 knuckles today. Can't wait to see them installed.

Single turbo manifold built earlier this year for a 4 door g35. Flipped headers with v-bands for easy removal.
04/19/2019

Single turbo manifold built earlier this year for a 4 door g35.
Flipped headers with v-bands for easy removal.

Address

Newport, MN
55055

Website

Alerts

Be the first to know and let us send you an email when Panda Built posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Panda Built:

Shortcuts

Share

Category