AMR Powersports LLC

07/21/2023

This 660 rhino isn’t having a good day! Time for a rebuild!

07/05/2023

Little brake conversion on this old Yamaha blaster! It was missing the entire cable driven rear brake so I built customs brackets and mounts to install a much better hydraulic brake. Picks are from test fit pre paint. Everything got cleaned, primed and painted black before it went back to the customer

06/20/2023

June’s been a rough months for the family so bear with me. Between loosing a nephew, grandmother, and now my mother in law just went in for emergency surgery this morning I’ve been out of the shop a lot and am getting behind on the vehicles I’m working on and have scheduled to come in. I’m doing the best I can to get caught up and back on schedule! Thank you for your understanding!

06/16/2023

At the request of several customers I’m now set up to take credit cards, google pay, and Apple Pay, ect, both at the shop and on my service calls!

05/24/2023

Yamaha Wolverine x4 was in for some accessories. Got a light bar, rock lights, and a winch!

05/07/2023

04/27/2023

Busy end of the week!

04/20/2023

Had an Rmax in for a quick cv boot replacement on a rear axle!

04/20/2023

Teryx 4 in for an audio system that was draining the battery even when off. Installed a cutoff relay as well as a fuse block for future accessories to resolve the issue. Also got a winch and a light bar while it was in!

03/15/2023

98 fortrax 300 in for refresh and some new tires! This is another one that’s sat for a few years and the owner wants to get back to riding it around again. It’s a Honda so I’m not expecting to much drama in getting it running…lol.

03/13/2023

Just a little YXZ rebuild! This motor was just rebuilt by another shop and only got 50 miles before it locked up! The rod bearings were completely shot so I’m guessing they didn’t check for proper clearance before reassembly. Also the output shaft was completely rusted and had been for a while looking at it. It was rebuilt the first time due to water pe*******on and this bearing was obviously trashed due to that and wasn’t replaced when it should have been! It’s a shame but this is why I opened my shop cause there are to many “shops” out there that don’t do stuff properly and don’t care to learn. Unfortunately this includes the mainstream dealers as well.

03/10/2023

2001 Polaris sportsman 90 came in for a bogging issue. Cleaned the carb which had a bit of junk in it but also found the clutches were filthy and worn down. A new set of clutches will have this little stroke back up and runner better then it has for a while I bet!