Tear 20 Customs

Website Contact the business

Tear 20 Customs 3d printed car accessories

Side by side: Bravetech vs. Tear 20 Customs. 💡 Bravetech's since shut down, but we still get asked how our LED density s...
10/20/2026

Side by side: Bravetech vs. Tear 20 Customs. 💡 Bravetech's since shut down, but we still get asked how our LED density stacks up against what's out there. Tear 20 customs on the right Brave tech on the left. The lens on ours is not glued on yet in this picture

Another piece of the dashboard puzzle: a dome light insert with 3 gauge pods built in. 📊
10/19/2026

Another piece of the dashboard puzzle: a dome light insert with 3 gauge pods built in. 📊

10/17/2026

Next step for keyless convenience: an electronic hood release. 🔓 One button under the dash and the latch pops — the factory cable pull is getting phased out.

10/16/2026

First step toward a hands-free hood: prototyping a 12V linear actuator to lift it open. 🔧 Had to design a custom top-pivot mount since the stock bracket doesn't clear.

Air ride is great until the push-to-connect fittings start leaking. Converting mine to AN line and upgrading to independ...
10/15/2026

Air ride is great until the push-to-connect fittings start leaking. Converting mine to AN line and upgrading to independent corner control while I'm at it.

10/14/2026

Next up in the Apex Pegasus lineup — RGB marker lights, fully controllable color on the front markers. 🌈 Here's an early test clip.

Still time to get on the list. 🙌 Headlights and tail lights are both moving into testing — testers hear first.
10/13/2026

Still time to get on the list. 🙌 Headlights and tail lights are both moving into testing — testers hear first.

Added a new printer to the shop — the Ideaformer IR3, a belt printer. 🖨️ Since it prints on a moving belt instead of a f...
10/12/2026

Added a new printer to the shop — the Ideaformer IR3, a belt printer. 🖨️ Since it prints on a moving belt instead of a flat bed, it's not boxed in by bed size — we can now print long parts in one continuous piece. Think tail lights, beltline trim — stuff that just wasn't practical on a normal printer before.

Tear 20 Customs keeps spreading. 🗺️28 states and counting — plus Alberta and Ontario up in Canada. Built in Ames, Iowa, ...
10/12/2026

Tear 20 Customs keeps spreading. 🗺️

28 states and counting — plus Alberta and Ontario up in Canada. Built in Ames, Iowa, shipped across North America.

If your state's not lit up yet, give us a reason to change that. 😉

Address

Ames, IA
50014

Website

Alerts

Be the first to know and let us send you an email when Tear 20 Customs posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Tear 20 Customs:

Shortcuts

Share

Category