Cranked Up Dyno Tuning

Cranked Up Dyno Tuning For your tuning needs, EFI or carb, NA or boosted, 2wd or 4wd
Based in Invercargill, New Zealand

Evo 8 with Link Engine Management plugin, 1000cc injectors, sinco exhaust manifold and Tdo6 turbo with 3inch exhaust run...
02/09/2026

Evo 8 with Link Engine Management plugin, 1000cc injectors, sinco exhaust manifold and Tdo6 turbo with 3inch exhaust running NPD100 pump fuel.
Good results with simple bolt ons.
Customer is in the process of adding some new sensors to log and be able to setup engine protection etc with.
A set of upgraded cams in this would be a great next upgrade Jack đŸ˜‰

Here is a Nissan Skyline R34 GTR, it got new HKS Co., Ltd. 264 drop in cams and adjustable cam gears.Also added a Link E...
28/07/2026

Here is a Nissan Skyline R34 GTR, it got new HKS Co., Ltd. 264 drop in cams and adjustable cam gears.
Also added a Link ECU can lambda to the previously installed Link G4x plugin ecu and upgraded Garrett 2860-5 turbos.
Carried out a retune after the cam install and it picked up some good power but unfortunately run into an issue with the upgraded turbos being installed with the factory wastegate actuators so was limited on boost. It will be back to get the actuators upgraded and the boost Cranked Up to see what can really do.
Was a privilege to work on this beautiful GTR, thank you Troy and looking forward to the next stage!

This EVO1 had been sitting not running for roughly 10 years and owner finally decided to get it running again. They had ...
09/06/2026

This EVO1 had been sitting not running for roughly 10 years and owner finally decided to get it running again. They had a no power problem so no start and that is when it came to me.
Worked out the fault and got it fired up for the custom and running. It then went away for a new exhaust system as previous system was a little on the rusty side.
Next stage was checking the tune but had some issues with the very dated ECU that was installed so the decision was made to upgrade to new Link ECU LinkECU G4x plug-in with can lambda and 8 button can keypad.
Carried out new tune on NPD100.
Had a slight misfire issue so upgraded to a new Platinum Racing Products coil on plug system which cured the missfire.
Also setup speedo signal for the new Haltech UC10 dash.
Replaced waterpump after the old 1 started to leak after sitting for so long and found engine mount to now be a 2 piece unit so replaced that too.
Customer is now getting car sorted and street legal then it will be back for a Q16 race fuel tune and then be ready to hit the streets and the drag strip.

A new UC10 dash install on a customers Mitsubishi EVO1 street/race car using a dash insert which fitted great and ma...
27/05/2026

A new UC10 dash install on a customers Mitsubishi EVO1 street/race car using a dash insert which fitted great and made the install so easy. The UC10 is a perfect fit and even better with the Haltech reverse camera setup too.

Address

Invercargill
9812

Website

Alerts

Be the first to know and let us send you an email when Cranked Up Dyno Tuning posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category