Port Flow Engineering

Port Flow Engineering Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from Port Flow Engineering, Automotive Service, Kelowna, BC.

New billet side cover from CMS installed. All buttoned up and ready to go-
04/17/2026

New billet side cover from CMS installed. All buttoned up and ready to go-

New Wavetrac diff, and speedometer mag drive ring- backlash and carrier bearing preload set.
04/17/2026

New Wavetrac diff, and speedometer mag drive ring- backlash and carrier bearing preload set.

Going back together, all new gears, synchros and bearings, lock-wired roll pins and steel 3-4 shift fork.
04/17/2026

Going back together, all new gears, synchros and bearings, lock-wired roll pins and steel 3-4 shift fork.

This was a big job. G50- 6 speed transaxle from a Porsche 964. Full re - gear to RSR ratios and rebuild will all genuine...
04/17/2026

This was a big job. G50- 6 speed transaxle from a Porsche 964. Full re - gear to RSR ratios and rebuild will all genuine parts, upgrade to a new Wavetrac diff and billet side cover from California Motorsports.

Trying to get the max out of these Edelbrock performer rpm sbc cylinder heads. Some finesse work needed, out of the box ...
02/18/2026

Trying to get the max out of these Edelbrock performer rpm sbc cylinder heads. Some finesse work needed, out of the box there is a sharp 90 degree wall where the chambers were machined for the valve seats. That will be machined to a smooth radius, and a larger 30 degree top cut added to the valve seats, and a 70 degree cut added to the exhaust seats.

The new exhaust valves finally arrived, so I was able to finish these up. Set the spring installed heights, and assembl...
02/04/2026

The new exhaust valves finally arrived, so I was able to finish these up. Set the spring installed heights, and assembled them with the titanium retainers- they're almost 30% lighter, which should allow a few hundred more rpm before valve float-

A quick tidy-up and port match for this Harley Screamin' Eagle 64mm intake manifold to these Screamin' Eagle cnc ported ...
12/03/2025

A quick tidy-up and port match for this Harley Screamin' Eagle 64mm intake manifold to these Screamin' Eagle cnc ported M8 heads -

Upgrade time for these Porsche 964 cylinder heads. New valve guides, stainless valves, multi angle seats, high rev valve...
11/18/2025

Upgrade time for these Porsche 964 cylinder heads. New valve guides, stainless valves, multi angle seats, high rev valve springs and titanium retainers.

A nice break from my usual work this morning, this was some challenging overhead welding adding a bracket for an adjusta...
10/15/2025

A nice break from my usual work this morning, this was some challenging overhead welding adding a bracket for an adjustable panhard bar to the front end of this super cool coupe-

Happy 50th birthday to my Trans Am. 50 years ago today it was delivered to its original owner in Vancouver B.C.
06/28/2025

Happy 50th birthday to my Trans Am. 50 years ago today it was delivered to its original owner in Vancouver B.C.

Address

Kelowna, BC

Website

Alerts

Be the first to know and let us send you an email when Port Flow Engineering posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Port Flow Engineering:

Shortcuts

Share

Category